Components and Architectural

I currently have 3x Sonos Play One and 3x Sonos Play 3. For christmas I was thinking of getting my dad a record player and either a connect / Play 5 so he can utilize his record collection. Can anyone reccomend: -A good record player to use with Sonos that looks and sounds good -Whether to get a Connect or Play 5 - Do I need an amp i.e. Connect:Amp or Play 5 with amp * Also with either Connect / Play 5 would I be able to use some sort of splitter to route the sound from my tv to Sonos (rather than keep switching the input from record player / TV) Thanks in advance

I’m in the process of setting up 2 separate outdoor areas with wired speakers that I want to set up as 2 Sonos zones. I understand that when setting up wired speakers, you wire each pair of speakers to its own connect amp to form the 2 zones. My question is, do both connect Amps need to be connected to my router, or does just one of the connect Amps need to be connected to the router? The rest of my house is a 5.1 in the living room and play 3’s in the bedroom ‘s and garage; once one of the connect Amps are connected to my router, can the rest of the house run wirelessly or would you recommend other devices be plugged into the router.

The room was dropped from my room list. Tried to power off with the same flashing lights reappearing

Just came home from vacation and now my tv sound won't come out of my playbar or sub....music works fine. It worked fine now it doesn't. Any suggestions?? Thanks!

I bought a house where the the downstairs is hardwired with 6 small (i.e. 3 double cube) Bose speakers inside and 2 Yamaha waterproof speakers on the deck. The speakers are driven by an old Pioneer AV receiver connected via an SS4 speaker selector with impedance protection. I have a Sonos Connect attached to the receiver to stream music on a hard disk attached to my router. I also have a CD player and a subwoofer connected to the receiver. I always play the same source on all 8 speakers and I’ve never had any problem playing all speakers at one time at a satisfactory volume through a single R/L pair of speaker outputs on the receiver. (Note this I don’t play surround material on this system - just basic stereo.) I want to replace the Pioneer receiver because it's too big, clunky and complicated for the space and what I need it to do. I also need to replace the Sonos Connect because it's one of the first units made and fails intermittently, requiring frequent resets. I’m think

Is there a Wifi output adaptor available I can fit to my analogue hifi amplifier to output a Wifi signal to be picked up by my Sonos controller to play on my Play 1? I want to play my CDs on my CD player through my amplifier then through my Play 1.

this is the second time in the same week I get the message sorry we can't connect to sonos. The first time I had to pull the plug on my router to sort it the second time it has not worked also i dont want to keep unplugging my router every week any thoughts.I have not changed anything only have a 1 and a 3 connected wirelessly.

I have a TV outside with a Directv mini Genie. I want to push my audio from the TV into the two outdoor speakers, and have the ability to change the source from the TV to any of my other music services. I have an unused coax cable that is running back to my wiring closet. I have drawn up the attached diagram for what I think I need to do, but I'm not sure if it is the best practice. Is there a better way?

Could someone confirm whether I can connect regular wired headphones to the analog out of a CONNECT (using a suitable RCA to headphone cord adaptor)? I.e., that I don't need to interpose some kind of headphone amp. Thanks.

Let me start by stating that I'm a 10 plus year Sonos user and I've been on the beta program in the past. I think I have an above average understanding of how this equipment works. That said, I have a ZP100 in my office with a turntable connected to it. Yes the turntable has a preamp built-in and yes it's connected to the inputs on the ZP100 but I cannot get the turntable to play through the ZP100. I followed the instructions on the site and run into issues where it says to "click on the line-in settings on the Room Settings menu". My issue is that no line-in menu shows up under room settings. Here's what mine shows... I've tried resetting the unit and that did not work. Every other function of the ZP100 works perfectly except for this one. I also tried on my ZP80 and both Play:1's and have the same result. I've got several hours invested so far and I'm out of ideas. Anyone have any pointers?

I know the Boost is working, based on the system info, but I'm wondering why the Boost Settings tab says You have no boosts in your sonos system - while I have. I'd love to be able to see the unit, just to 'make it 100%' valid.

I am trying to use the line-in on my Connect:Amp. However, when I have a device plugged into the phono sockets, the following message appears: "To use line-in, connect a device to a line-in capable sonos player" - i.e. the Connect:Amp is not 'seeing' the Line-in connection. I have already tried the following: Swapped the phono cables over - no luck Rebooted the Sonos Connect:Amp - no luck Factory reset the Sonos Connect:Amp and added back to the system - no luck Then I connected the same line-in device to my Sonos Connect - the line-in does show up and works OK Used the same cables to re-connect to the Connect:Amp - still no luck I can only conclude that something is up with the Connect: Amp Can anybody help? Advice would be greatly appreciated. I have submitted a diagnostics report: #7976997 Thank you!

Hello all - first post. Brand new to Sonos and loving it! I purchased 2 Connect Amps, and 2 Play 1's. The first Connect Amp powers 4 ceiling speakers (2 in Master Bath and 2 in Master Bedroom) and the other Connect Amp powers 4 ceiling speakers in living room/kitchen area. Here is my question: When I ordered my speakers, I thought they were all 8 ohms. The bathroom speakers came in first, and they are both 8 ohms (these were "weather resistant" so different from the others). Got them installed and they sound great. The rest of the speakers came in a week later, and I got them all installed and they all work and sound great too. But I noticed in some documentation that came with the other 6 speakers that they say 4-8ohms. Now I'm worried that I may cause damage to my very expensive Connect Amps. So one of the Connect Amps is running 2 8 ohm speakers and 2 rated 4-8 ohms, and the other Connect Amp is running 4 4-8 ohm speakrs. After running them for quite a while, sound is st

HOW DO I ADD MY SOUNDBAR TO MY SONOS CONNECT: AMP SYSTEM?

I am thinking of getting a Sonos CONNECT AMP and hooking it to my TV. When hooked to my TV can I still control the volume with my TV remote or do I have to use the Sonos app?

I use a connect amp using Airplay, my question is if I play music to my connect amp (the source beeing the line in, will this signal be sent also to other sonos speakers in the sistem?for example a play 1?)

I have a Sonos Soundbar and two PLAY 1s connected via my broadband router, which also connects to my PC holding digitised CDs. Is there any way I can connect headphones to listen to internet radio and my CDs instead of through the speakers?

Just set it up today, after 3 hours it cut off. Rebooted, unplugged, nothing. Wired speakers still work (Connect Amp). Do I need a new AMP?

I bought the Sonos 5 to stream music period!. If I wanted a snooping, listening always on "assistant" I would have bought the Google Home or the Amazon Alexa. If I am forced to add this capability to my Sonos 5 with a mandatory "upgrade" I would rather brick the device and simply use it as a Powered Speaker...

I have a pair of Vienna Acoustic speakers rated at 4-ohms. I'm considering switching to a Sonos Amp, but wondering if that will work given Sonos lists the amp at 8-ohms. Does this just mean it will pull more power to get the same volume or are there any issues risks here?

Anyone seen pictures of the new Wrensilva Sonos Edition Console which incorporates two Play 5s? I think it’s hideous but leaving that aside I hope Sonos haven’t devoted much time and resources to this product when requests and suggestions from users for enhancements to the current line-up apparently get ignored or dismissed. Only a personal opinion! :8

So I've got a TV in the master BR. I've got left and right speakers powered by a SONO AMP in a different room so I can play music. I want to be able to connect the speakers to my TV using the SONOS connect via the Fiber connection to the TV. Can I then associate the L&R speakers connected to the AMP to get TV "Out"?

Does the Sub need any maintenance in terms of ridding it of accumulated dust where visible? I have mine under a cloth cover that is effective but over the years, dust penetrates. I am a little reluctant to use a brush because I don't know how robust/delicate the two driver cones and surrounds are, hence the question.

Hi, everybody, i´m having issues with a set-up. I have a RCA output wired to the LINE-IN of a CONNECT in the living room, and i want to be able to play it (the connect´s LINE-IN) wirelessly in a CONNECT:AMP located in another room. i tried setting both of them in a group, but it didn´t work. How can i go about doing this? i´m fairly new to Sonos, so i may have skipped some steps in the configuration. Thanks in advance for the help!

Hey everyone. I have a bunch of sonos speakers at my place that I love but I started to get into vinyl recently and picked up a great turntable. I wanted to grab a sonos connect to connect the turntable to my sonos system but the price ($508 canadian after taxes) is too high for me at the moment. But there is a person close by who is willing to sell me their sonos connect for $175. I noticed it has the older buttons (mute instead of the play/pause), they claim it's only 2 year old but I have sonos play 1 speakers older than that and they have the new buttons so I don't know. The guy seems fine and trust worthy and I would like to pick up this unit. Does anyone have any advice for me? And when you buy used sonos gear, can I still register the serial number to my account?