Fix & Optimize

Since Tidal in itself is supported I would love to see Voice Control integration as well.I found it somewhat confusing saying everywhere that Tidal is supported but the Voice control is not. 

I have 3 Sonos speakers. I use them always. This morning my app showed ”No Content” under the name I gave each speaker. I rebooted a speaker but still no content. I checked my router and it shows the speakers all connected to the network. I was using Sirius programming and in the Sonos app it showed as working with the name of the song, etc. One of my speakers is a Roam 2 that was not powered on. I powered it on and it showed on the network but had the same message of no content and i couldn’t play anything on any of the speakers. So, I’m not sure what the issue as and i think i did the things I should. Any suggestions?

Hello,I have an HHP Omnibook laptop using windows 11 with the sonos (s2 controller) app installed.  I have tried everything in the articles that I have been reading from sharing the folder, turning off my firewall (windows firewall is the only one I have), using the ip address in the folder name, etc.The music library that I am attempting to add is on the hard drive of this laptop.  I get the following error:  “sonos was unable to add the music folder reason:  unable to add the shared folder //scottnewlap/singles to your music library (1001).If anyone knows of a fix, I would greatly appreciate it.  Have a great day.Regards,Scott

Your Sonos app doesn't work and Spotify app never plays . It it does play it will pause or skips songs right after this is not acceptable.  Why did everything get worse this week and he's my app is updated and speakers for the last update 

My Sonos one microphone light won’t come on and mic won’t work 

Hey folks, For ~15 years I’ve been running a set of external speakers with internal powered subwoofers (Definitive ProTower 400s) through an NAD 320BEE receiver to a Sonos Connect (gen1) to a Sonos S1 system.  I stuck with S1 mostly because the Connect didn’t support S2 and also because I primarily listen to local library, but not interested in reopening the S1/S2 wars here... There are also a bunch of other Sonos speakers in other rooms but that doesn’t seem relevant to this problem. The NAD recently died on me and I’m considering my options.  I could buy a new receiver but it seems like overkill as I only use it to connect the speakers to the Connect.  I could buy a Sonos Amp, which seems the most straight ahead option but then I’m throwing out a perfectly good Connect. I could buy some some new Sonos speakers, but again, then I’m throwing out some very good speakers as well as the Connect.  Are there are other options I should consider, perhaps some good quality mini-amp I should kn

I have the Sonos Ace and I’m enjoying it at home, but I’d like to take it to work. Work does not let me use bluetooth, and the usb c to 3.5 audio cable that came in the box is too short for my needs. I have a 3.5 female port to usb-c cable. (Specifically this one.) And I have an audio jack to audio jack cable. (Specifically this one.) But I cannot get them to play audio through the Sonos ace in this configuration. The Sonos Ace is fully updated. Do I need to buy yet more cables?

can you have sonos in ceiling speaker in a poolroom ?

Morning,Over the weekend my W11 Desktop Sonos App (v. 11.15.4) has the ‘Update Now’ option listing.However, the update never works - it appears to download the new version, and then immediately get ‘Update Failed’ message and to contact Sonos Customer Care.Submitted diagnostics ref : *********Any suggestions would be much appreciated,Thanks.Mark Moderator Edit - Removed and recorded diagnostic number.

Lately, my Sonos has been randomly playing music. On way day it literally was playing music over a documentary I was watching which confounded me to the max. One day I come home from work to my house which had been empty all day and the music is on full blast.  I tell Alexa the stop the music and it does only to resume a few hours later.  I read this was a problem 7 years ago but no solution was ever provided. Anything new do October 2025? I don’t have any music apps connected so what’s next?

装着検出が効かない Moderator Edit - Translation by Google:Wearing detection does not work

Hej jag bytte router på nätverk vilket gav mig ny WiFi adress. Då upptäckte jag att Sonos1 fortfarande fungerade med min gamla Controller 200 via den hittar jag mina enheter men jag kan inte se mitt system via appen Sonos 1 i telefon som då har det nya WiFi namnet. Jag kan inte lägga in in ny musik på mina 2 NAS som sköter mitt musikbibliotek.Jag tror systemet går på den WiFi som Sonos själva hade när systemet startades upp. Mitt system är från 2008 så jag har varit med länge. Nu vill jag få över systemet till mitt nya WiFi för att kunna hanter ny musik, lyssna på radio och andra musikkanaler som inte går att få in på det WiFi nät Sonos ligger på nu.Öppnar jag min Sonos1 app på telefonen så hittar den inte mitt system. Hur gör jag för att få över systemet till mitt nyaa WiFi som går via en Telia Router och ett TP Link Mesh system?mvhTommy Palm 

Hi - having some problems with using a record player with my system.  Currently have:record player with built in phono Move 2 RaySo I connect the record player to the Move 2 via aux. this works fine, and sound comes out of the Move only once record starts. Then I need to manually connect the Ray to the Move to hav it play out of both speakers.  But a few things that make player my vinyls less than convenient:  every time a record stops, my Ray disconnects  sometimes the Ray won’t pair with the Move Sometimes there is a lag with the RayAm I possibly doing something wrong? Is there a way to ensure the Ray always connects to the Move when it stays playing the record? Thanks! 

I had the old system for a loooong time. Just set up new system few weeks ago. Had some guests over and using my phone i went to increase the volume of my 300 (kitchen) speaker in the GROUP of 5 speakers... the setting was on 15. I used the slider to increase it to 30 but within seconds it would go back to the original setting of 15. All other speakers dont seem to do this (i have 2 100s and a MOVE 2 and a TV sonos sound bar. 

Hi, I bought a home with 3 Sonos Connect:Apps powering 3 zones with built-in speakers. All fine there. There’s also a Sonos Connect and wires for 4 built-in ceiling speakers labeled right/left Middle and right/left Rear that are meant for the tv.I’d like to have 5.1 sound from the tv (Center, right/left Middle, right/left Rear, Bass) and I’d like the ceiling speakers to link to my Sonos home system to play music as the other zones do.I’m not sure what’s needed.A Sonos App would power the speakers, but not as both Middle and Rear (two zones need two Apps, right?), and I’d still need to do something about a Center speaker or bar. Expensive to have 2 or 3 Apps just to get 5.1 sound from the tv.Or perhaps a receiver to run all the speakers, but then not sure how to connect to Sonos and have the tv ceiling speakers join the other Sonos zones to play music simultaneously. 

Every other time there’s an update to the app, my Roam won’t create a stereo pair. I’ve had them for a a long time and used them a lot as a stereo pair. For whatever reason when I have to update the app, they won’t work until there’s another update to the app. Then, they work again until there’s another update to the app. It’s really frustrating because I use them all the time. Multiple times I’ve tried factory resets on both speakers, deleted the app from my phone and created a new system. My 2 Roam just won’t create a stereo pair right now. Hopefully it will get fixed again with the next app update.

I’ve had this problem for a couple months now and been in contact with Sony about it.Every time I turn on my TV I get a message in the bottom of the screen saying “TV speakers active due to a audio system communication error”. It started appearing after updating both my TV and Sonos Arc so it’s hard to say which is causing the issue.Sound is still coming from the Arc but sometimes I have to manually change audio source from “TV speakers” to “Audio system” but it’s rare.Do anyone else have this problem?

Hello  Looking to fit Sonos home theatre surround sound in my new extension. Only choice I’ve got is to use ceiling speakers with the sub and arc. It’s 5x7m with a vaulted ceiling. Would you go for four 6inch or two 8inch speakers guys? 

I’m using the Sonos Ace with my MacBook Air over USB-C while listening on Apple Music, and I’ve noticed something weird. When I take the headphones off, the music keeps playing, but when I put them back on, the music stops. Is that supposed to happen? It doesn’t do this on my iPhone 16 Pro or iPad Pro with the same USB-C cable. The wear detection is working normal with bluetooth.

For the past few weeks, I've been having issues with all my Sonos speakers when using Spotify Connect.  For example, if I've previously used another service like Apple Music or Amazon Music and then open the Spotify app and connect to a speaker, nothing plays.I have to start Spotify playback from the Sonos app first, and only then can I connect via Spotify Connect from the Spotify app.  This has been happening for about two weeks now.It's really annoying because if you start directly from the Spotify app, there's no way to hear anything—it’s as if the speaker doesn’t activate. But in Spotify appears like the song is playing. Thanks!Edit: In Reddit there are people with the same problem https://www.reddit.com/r/sonos/comments/1nobv3y/anyone_else_been_having_problems_with_spotify/

Using S2 Build 80.29.6-release+20250918.549b8db on Android when I play from a playlist and click on the playlist button located bottom left in the UI I’m taken to the playlist successfully but the track shown as being played is always one below what is actually being played. The playlist button always takes me to TrackBeingPlayed+1If it makes any difference, the playlist is playing files stored locally on my Sonos Library, not Amazon, Bandcamp etc.As an example in the image below, the track being played was RAH Band - Electric Fling but Dwight Druick - Georgy Porgy was showing as the track being played Is this a known issue with playlists?

I don’t have a TV. I’ve bought a Sonos arc ultra, gen 4 sub and era300. I have a FeinTech VAX04101A hdmi switch to connect fire stick, Blu-ray player and ps5 to Sonos arc ultra and projector. Projector only has normal hdmi and not eARC but Sonos app wants eARC output from source which I don’t have. Does that mean I can’t connect my sources to Sonos? I need it to work with hdmi not eARC hdmi, is that impossible?

I have never had a problem in years with my sonos and all of a sudden in the last few weeks its been a headache. I initially could see all my devices on my app, but when going to play music, it would show as if it was playing but no sound.  So I reinstalled the app, no luck. I factory reset each item and still when I go to add it, it fails at the updating stage with the exclamation mark and try again. Cannot finalize the connection.  I now have a dead system and have tried unplugging all items and the router for 15 min and then pluging the sonos back in. Nothing is working. Both the computer app (mac) and the iphone.  I keep getting 1067 and 1066 errors and try again when trying to update. I am at my wits end. Any one have the same issues? Thoughts?

Once again, Radioplayer is no longer working after the Sonos update on October 6th.... This is really annoying!!!!!!!!   

Has anyone had issues with a sub gen 2? I disconnected it (was working).  I moved it to another room however when I connected to power in a new room the light did not turn on.  I cannot connect it to my system either. I tried resetting however the light does not work.  Did my Sub just die?