Trueplay “lost speaker” issue
Halfway through my trueplay tuning while walking around the room, the app stops and reports a “lost speaker.” I can’t finish the tuning repeatedly. My sub and playbase are both functioning. Any ideas? I’m on iPhone X and iOS 11.4. Thanks
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Oops. Memory played me wrong, I should have looked it up. You're absolutely correct. Been a while since I've dealt with RJ11 at all.
Have exactly the same issue
Halfway through Trueplay tuning, the process stops with a message "Lost Speaker...."
My setup:
Playbase
2 x Play 1
Sub
Sonos diagnostic confirmation number: 1736608569
Thanks for any help!
Halfway through Trueplay tuning, the process stops with a message "Lost Speaker...."
My setup:
Playbase
2 x Play 1
Sub
Sonos diagnostic confirmation number: 1736608569
Thanks for any help!
This has happened to me several times and I have fixed it the same way each time.
My set up:
beam wired
connect amp wired powering surround speakers
Each time I factory reset the beam and connect amp and then successfully set up the surround speakers with the beam.
My set up:
beam wired
connect amp wired powering surround speakers
Each time I factory reset the beam and connect amp and then successfully set up the surround speakers with the beam.
Identical issue as all above. Speakers work fine but when trying to Trueplay tune it stops halfway and says it cannot hear one speaker. I hear it just fine. I rebooted my entire system - router, boost and every single Sonos speaker in the house - still the same result.
Opened issue with Sonos already - diagnostic 1711001441. Hopind someone at Sonos can help.
Opened issue with Sonos already - diagnostic 1711001441. Hopind someone at Sonos can help.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.