Trueplay “lost speaker” issue
Userlevel 1
Halfway through my trueplay tuning while walking around the room, the app stops and reports a “lost speaker.” I can’t finish the tuning repeatedly. My sub and playbase are both functioning. Any ideas? I’m on iPhone X and iOS 11.4. Thanks
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Page 2 / 2
CAT 5 or CAT6, more likely. RJ45 is a telephone cable. 🙂
It’s at Cat6 cable with an RJ45 connector. RJ11 is a telephone connector.
Oops. Memory played me wrong, I should have looked it up. You're absolutely correct. Been a while since I've dealt with RJ11 at all.
This has happened to me several times and I have fixed it the same way each time.
My set up:
beam wired
connect amp wired powering surround speakers
Each time I factory reset the beam and connect amp and then successfully set up the surround speakers with the beam.
My set up:
beam wired
connect amp wired powering surround speakers
Each time I factory reset the beam and connect amp and then successfully set up the surround speakers with the beam.
Page 2 / 2
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.