Components & Architectural

I am building a three story home and would like in ceiling speakers in the following areas: Basement: Living room, bedroom #4, Bedroom #5 First Floor: (Living Room & Kitchen) , outside deck, and garage Second Floor: Master bedroom, Bedroom #3 and Bedroom #2 The goal is that each of these rooms could be playing different music controlled by an individual. I am thinking of Klipsch speakers. My questions: 1) Do each of the klipsch speakers need speaker wire ran to connect Amp? 2) How many connnect amps will I need? 3) Why would I need wall mounted audio controls installed? I've seen this recommended. 4) are the speakers connected to the cat5 cables? 5) If I have multiple connect amps, can i still control them from one app for the entire house? 6) I believe I run the speaker wires to the connect amp, and then ethernet cable from connect amp to the cable modem. Any help I can get, I would appreciate it. Thanks.

Hi moved2 play 1's last night to use with a sound bar, when I've moved them back one of them won't reconnect back and the room name has disappeared just got a solid white light , how do I connect it back in?

Hello Everyone, I am new to Sonos. I just purchased a Sonos Connect music streaming device yesterday and connected it to my 28 year old Sony GX60ES Receiver and I am thrilled with being able to stream all my music from my iPhone! It works extremely well! However, I have a few questions about my speaker set up with 4 speakers and whether or not I should keep the Sony GX60ES receiver or switch to a Sonos Connect AMP. Below are the details: I just purchased 2 Bowers and Wilkins ceiling speakers to put into the kitchen ceiling. Here are the specs for the speakers: Bowers & Wilkins - CCM 683 8" 2-Way In-Ceiling Speakers (Pair) RMS Power 130 Watts impedance8 ohms Peak Power Handling130 watts Minimum Frequency Response35 hertz Maximum Frequency Response50 kilohertz Sensitivity88 decibels My plan is to have these 2 ceiling speakers hard wired to my 28 year old Sony GX60ES Receiver that has power output 100 watts per channel into 8 ohms and frequency response 5-50 h

Hi, I currently have a playbar and 2 play 1's for the sound on my tv, I was playing yesterday and in error managed to get the tv sound out of the play 1's and not the playbar. I have always believed that this is not possible and at the time the playbar was not connected to the router, so how did this happen?

My daughter accidentally placed a candle near my sound bar which cause the fabric to melt Can this be replaced?

I have wires set up for two outdoor speakers and 3 sonos play 1's that I would like to add to out exhisting sonos system. Our exhisting system has a sonos connect running an amp that conrols 6 sets of ceiling speakers and a radio. Can the sonos amp run two wired in speakers and three sonos play 1's? What specs on the speakers do I need to look for to be compatible with the sonos amp? Or what would I need to add two wired in speakers and three sonos play 1's to our exhisting system?

I have a question regarding how the connect:amp auto play feature works. Based on the user manual, it appears the amp will detect once Alexa is outputting audio. So for example, if streaming audio from within the sonos app and I said "Alexa what is the forecast", sonos streaming would stop and I would hear the forecast from Alexa. Can someone tell me what would happen after the forecast is complete? Would sonos streaming resume or would it be on pause? Thanks!

HI, Some websites indicate that we'll see a nice discount on friday. If so, i would like to order an extra Play1, but i noticed that Sonos only ship to USA. Is it possible to ship one to Europe? Kind regards Kjell Provost

I've recently acquired an Audio Technica AT-LP120 turntable and am looking into connecting it to my Sonos system. I've scoured the forums and am pretty sure about the answer, but thought I'd double check with you guys. The turntable has a built-in preamp, so am I right in assuming that I can wire it to a Connect and stream it to my Sonos speakers without the need for a separate amplifier? There won't be any speakers wired directly to the turntable (I've already got a Connect:Amp wired to some Cambridge Audio floorstanders in the living room, but the boss won't allow a turntable in there!). Thanks in advance.

What states will you ship to and not charge sales tax

Hi Im going away for the weekend to a cottage that has broadband but possibly not direct access to the router. I wish to take my play 1 pair plus sub. At home, my sub is bonded to connect amp. Can anyone please tell me the steps required for the play 1s and sub to work together at the cottage and also still integrate straight back into my existing setup when i return home? Thanks

Are there any significant differences between the First Generation Connect Amp and the current generation? I know that the first gen is a good deal larger than the current generation but I'm curious if there are any compatibility or software limitations with the current Amp being used on my new Sonos system. Thanks.

I have the Marantz NR 1605 and just got a Sonos Connect so I can stream through the surround sound speakers. I have tried using the Analog Out from the Connect into the CD analog slot. I have also connected the Digital Audio cable from the Connect to the Marantz. I have configured the Marantz (I think) so that the the Digital Audio is for the "CD" and also have the Analog 3 for the CD (which is supposed to be the default). Nothing seems to be working.

Howdy So I just got the Sonos Play:5 today to connect my turntable into. The turntable has the required pre-amp to connect to the play:5 and it is working and playing my records just fine, but the volume isn''t even close to that of just playing Spotify through the Play:5. I literally have it turned up to the max volume, and it's loud, but i can't get it up past half way with non-vinyl audio without it blasting me out of the room. Do I need to get an additional amp to go in-between the turntable and the sonos system? Am I doing something wrong? Thanks in advance for your reply. Cheers!

My setup consists of an AT&T Uverse modem/router in downstairs bedroom, a Play 5 in next room over and a Sonos Connect upstairs and on the other side of the house. I frequently go long periods of time without having any network or dropout issues. But lately I have been having all kinds of problems. All of a sudden I can't browse my library, or one of my zones disappears, or songs drop out for no real reason and will do so repeatedly. Then all of a sudden it comes back on. Or just goes completely haywire and goes to the next track and plays 10 seconds before dropping out again and displaying the "insufficient buffer" error. I suspect that part of the problem might be the signal from AT&T. I pay for the 18 Mbps plan but am lucky to get 10-12. And this can drop down to the single digits during peak hours. This is the fastest plan available at my location and AT&T is the only game in town at the moment. So switching ISP is not an option. So I have tried various things like wiring in the

I can see all of my rooms from the Sonos App on my iPhone but am missing a room on the Sonos App on my iPad. How do I get a room back on my iPad? Thank you in advance!

Newbie here. So, I just upgraded (ha!) my wireless network, getting rid of the Comcast modem and router nd installed a TP-Link AC3150. Now my Sonos controller wont see the network, even when connected via Ethernet to the router. All other devices, with the exception of an older kindle, see the network with no problems. Any help would be greatly appreciated. thanks! yanceylebeef

Wouldn't it be great if you could fit ceiling speakers throughout your home and they were all Sonos. Who would like them....?

Hello! I recently had my first experience with Sonos while staying at a vacation rental and I am sold :) I have a living room Sony sound bar and sub that work quite well so I'm thinking of buying a play 1 pair for a kitchen and bedroom speaker and then a connect for the Sony. I primarily use an Xbox for all media cconsumption which routes audio and video into the Sony via HDMI, Sony plays audio, then routes video to TV (which is just a glorified monitor now) via HDMI. Questions arise when I have a connect running into the Sony. I'm assuming I'll have a new audio input from Connect into the Sony so ill need to switch between those to get either Xbox video/audio or streaming Sonos to work? Also will the Sonos connect turn on my Sony or will I need to either leave it on 24/7 or turn it on manually when I want to stream music? Anything else I'm missing here? Thanks a ton!

Hi folks - I have a 5 piece Sonos system in multiple rooms within our house. Wifi network is secure and working perfectly. Speakers are on separate breakers in a new house. Everything was great for almost a year then without warning, two Play 1s and a Play 3 stopped being recognized by the app on my phone. I've been through the set up process multiple times but the speakers are no longer being picked up and I'm getting a solid orange light (which suggests over heating... only they're cold... and it's November) Please help me wonderful community! Getting really frustrated as we have family staying for the holidays and one of the main reasons I got this system was for occasions like Thanksgiving! If it doesn't work soon then I'll get a refund and kit my house out with a competitor system... Thanks

Can Sonos speakers be safely used outside being exposed to water

As of this am (11/19/2016) my system is not working. I've rebooted routers, computers, phones etc. Reconnected my Sonos Boost and unplugged and plunged back in several of my speakers (over 10 in the house). Of course Sonos support is mon - fri. Anyone else experiencing connection problems?

Hi. I ordered a CONNECT:AMP to setup up a new room with my KRK Rokit6 powered speakers, and I think I might really need a CONNECT. The KRK speakers have RCA cables, and I'm not sure I can connect them to the CONNECT:AMP. If I can, would it require an RCA to Speaker Wire cable? Thanks, Bill

Hi, sorry if this has already been answered but if it has my search skills are poor. I'm looking to purchase a Turntable to play some of my old LP's and have come across the Audio Technica AT-LP5 which looks to get good reviews and was wondering what i would need to connect it to my current Sonos setup of Soundbar, Sub and 2 x Play 1's all connected with the Sonos Boost for my Wifi. I can see that Sonos have two options in the Connect and the Connect:Amp but would rather not buy the more expensive Connect:Amp if it will just as additional features that i don't need. Thanks in advance for any response to my questions.

hi there I tried to set up a pair of Play:1's and a single Play:3 in the same room (kitchen), but I didn't manage to do so. Is that even possible? Everytime I tried to add the Play:3 as a new player, it kept ending up in the old room it was in before. And just changing the rooms name of the play:3 to kitchen wouldn't work either.