I try to configure a 2d hand Connect S1.
I Have already reinit the Connect by pressing “audio” while connecting to power.
But I still receive “Product not found” message.
Answer
Connect S1 : "Product not found"
Best answer by GuitarSuperstar
Reset the Connect by following the steps at the bottom of this article:
https://support.sonos.com/fr-be/article/reset-your-sonos-product
Then try to set up the Connect again in the Sonos app by following the instructions in this article:
https://support.sonos.com/nl-be/article/set-up-your-sonos-connect
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Reset the Connect by following the steps at the bottom of this article:
https://support.sonos.com/fr-be/article/reset-your-sonos-product
Then try to set up the Connect again in the Sonos app by following the instructions in this article:
https://support.sonos.com/nl-be/article/set-up-your-sonos-connect
+24It could have been deliberately bricked as a part of the very short-lived Recycle program. If the S1 Sonos app still can’t find it, hard-wire it with Ethernet and run my app “Phonos Plus” on iOS, it will tell you if the device can be found and whether it has been DEACTIVATED which is how bricked devices report themselves.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.