I suggest a capability in the Controller App.
BLUF: When you group rooms, the volume levels are set in order to achieve balance and equality.
Situation. In my great room (living room, kitchen, eating area) I have the playbar, sub, and a pair of play 2 for my TV. I also have a pair of play 3 near the TV and a pair of play 1 at the other end of the great room. In this great room I have three "rooms" in Sonos. TV room (playbar...), Music Room (Play 5), and the kitchen (play 1). Sometimes I like to group them all together. When I do this, I have to adjust the volume for each room in order to achieve balance/ equality.
Could there be a present or another way to group rooms with a present volume control? Or, to create a room of several rooms and then establish levels using the setup?
Suggest Same Volume Levels When You Group Rooms
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
+22I personally would rather it not. Especially on units like a Connect where the volume may be purposefully low because the volume is being controlled by an attached amplifier. I may also have rooms that I don't want even close to the currently playing room volume.
I prefer volume at last played in that room. If I'm concerned with what a volume in room is before I group I go to that room and adjust the volume before grouping in.
I prefer volume at last played in that room. If I'm concerned with what a volume in room is before I group I go to that room and adjust the volume before grouping in.
Chris, thanks reading and adding your input. I agree with you.
Perhaps I didn't convey exactly what I am trying to do.
I have a number of speakers (8 total) in one room. The speakers are paired together or part of the playbar system. Sometimes I like to play all the speakers at the same time. When I play them all at the same time I have to adjust the mix. Perhaps if there was a room where you could add more than two speakers (besides the playbar tv room) and adjust them mix using truplay. I too use the line-in for my turntable and and tape and there is no issue when I adjust the mix for all the speakers.
Perhaps I didn't convey exactly what I am trying to do.
I have a number of speakers (8 total) in one room. The speakers are paired together or part of the playbar system. Sometimes I like to play all the speakers at the same time. When I play them all at the same time I have to adjust the mix. Perhaps if there was a room where you could add more than two speakers (besides the playbar tv room) and adjust them mix using truplay. I too use the line-in for my turntable and and tape and there is no issue when I adjust the mix for all the speakers.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.