Sonos connect S2 drops from ethernet wired network

What are the ports connected to? There should only be one port connected to your router/network.

Can you see the internal web server?

(use your IP here, not mine)

http://172.16.1.115:1400/support/review

​@Pools-3015 I am only using one port, it is connected to a switch then into my unifi router. I have set up the router to reserve a permanent IP address for my Connect.

​@Stanley_4 When I reconnect I can indeed reach the internal web server, where I get the following

Unnamed Room (RINCON_949F3EB8553A01400)
Living Room (R) (RINCON_7828CAAF955001400)
Living Room (L) (RINCON_7828CAAF959C01400)
Network Matrix

My Living Room R+L is a pair of Play:1 speakers that work fine (also on fixed IP addresses, via wifi) and Unnamed Room is (I suppose) the connect itself.

Below are some of the diagnostics I can see (when connected), not sure if this points in any particular direction.

Your help is appreciated.

​@Stanley_4 updated network matrix when reset and playing looks like this:

​@Panorama,

I’m not sure if this will assist, but…

Have you set the router to support multicast device discovery? - I’m assuming your Sonos controller device is just having difficulty discovering your ‘Connect’ on the LAN subnet. See this from the router manufacturers website:

https://help.ui.com/hc/en-us/articles/18930473041047-Best-Practices-for-Sonos-Devices

There’s also this link mentioned (found via a search here in the community)…

https://github.com/IngmarStein/unifi-sonos-doc

The link check was to see if the Connect was actually working after the Factory Reset, the actual data is of little use. Since it appears to be functional and communicating on the LAN that rules them out as problems.

After the Factory Reset (how I hate the mess that usually makes) did you go through the process of adding the Connect back to your system or is this where things are failing?

If it added back in without issue but isn't being found a network refresh is sometimes helpful. Power down all Sonos, reboot router and Controller, power up the Sonos. You do have static IPs set for all?

If all of that is working but you still have issues then Ken's suggestions would be my next try.

Thanks ​@Stanley_4  and ​@Ken_Griffiths - sadly none of this remediated the issue. Even after a reset of my App, my Unify router, Netgear Prosafe 24 Switch, Connect Gen2 and unpowering of my only other Sonos gear (2x Play:1) my unit still drops from the network (fast but faintly flickering white LED, all LAN status leds at the two ethernet ports burning solidly (incl. unused port), unit becomes invisible on app) - all symptoms look very similar to this case:

Connect Gen 2 drops connection

I am considering sending my Connect gen2 to the people at Isonatec in Germany as it seems like a hardware failure. Maybe I need to downgrade to S1 as the most recent firmware seems to have memory or memory leak issues.

Without a Connect (or expensive ‘Port’) unit my Play:1 speakers become pretty useless in a HiFi setting as they are not compatible with Airplay2 and they have no line input, so the only way to get audio from my AV Receiver to them is via a Sonos solution. Pretty disappointed with the reliability after “updates”.

What happens if you take the Switch out of the equation and just cable the ‘Connect’ direct to the router?

The flickering light is not good.

Compare repair prices to other options.

Why not use one of the less expensive Sonos options that offer a line-in? A Era 100 and adapter would be my first choice.

A used Connect is also possibility.