I recently added a Connect so my Klipsch Sixes could play the same music with my Play:1’s. I’m using the phono outlet on the Sixes and line out on the Connect (the optical is broken). If I play the music very quietly it doesn’t sound bad, not great but not bad. As soon as I turn the volume up there is an incredible amount of distortion in the Sixes and I can’t figure out why. Any advice? I want to crank all of them at the same time.
Answer
Sound distortion when Connect added
Best answer by Ken_Griffiths
I think the Speakers have an integrated phono pre-amp and its possibly that causing the distortion I think there is a switch to change the phono input to analogue RCA ‘line-in’ - see attached, but not sure where the switch is located 🤷♂️. HTH
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
I think the Speakers have an integrated phono pre-amp and its possibly that causing the distortion I think there is a switch to change the phono input to analogue RCA ‘line-in’ - see attached, but not sure where the switch is located 🤷♂️. HTH
Ken, you’re a genius! So simple yet i over looked it. That was all it took and I’m shaking the back half of the house again, thank you so much!!!
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.