i looked online, but can anyone suggest the crossover frequency in the sonos amp with a sub when the architctural speakers are detected? the default is 80 but those speakers appear to go below 50.
Answered
sonos architectural (sonance) outdoor speakers
Best answer by Stanley_4
It isn't how far down the primary speakers go, it is what point you get the best sound by redirecting lower frequencies to the Sub.
My old AVR and sub setup had main speakers good to about 60 Hz but they sounded better, particularly when playing loud, if I set the crossover to 120 HD.
It isn't a difficult task to select a good test track and try various settings to see what sounds best. Asking someone to suggest a setting is a bit like asking them how much sugar to add to your drink. Your taste, not theirs is important.
It isn't how far down the primary speakers go, it is what point you get the best sound by redirecting lower frequencies to the Sub.
My old AVR and sub setup had main speakers good to about 60 Hz but they sounded better, particularly when playing loud, if I set the crossover to 120 HD.
It isn't a difficult task to select a good test track and try various settings to see what sounds best. Asking someone to suggest a setting is a bit like asking them how much sugar to add to your drink. Your taste, not theirs is important.
totally aware of the ear / listening format to determine the best crossover setting. i was just asking if there was a suggested one when DSP is on using only sonos products as a recommended setting. without DSP it would start at 80 and then customize from there.
+19I like my crossover to be as low as possible depending, of course, on the L/R speaker frequency curve. If the sub is crossed over too high it becomes easier to locate its position in the room. You don’t ever want to be able to hear the subwoofer directly; It should add the lower frequencies without knowing where they are coming from.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.