I am struggling with how I’m going to bring wiring through stucco wall (no attic or basement) for the amp to be inside my living room. Any ideas would be greatly appreciated
Answered
sonance install
Best answer by Stanley_4
Drilling through a stucco wall is simple enough. Simpler if you get the right drill bit for the job.
You will also want wire shields on both ends of the wire to avoid abrading it on rough edges.
Note the hole in the bit for pulling the wire back through the hole, far easier than trying to fish it through after you have removed the bit.
First hits to get you a picture, shop around.
https://www.amazon.com/Bosch-BH2003T-18-Installer-Bit/dp/B00L2592OM/ref=sr_1_6
https://www.amazon.com/Through-Bushing-Insert-Protector-Wire/dp/B00UD076EK/ref=sr_1_5
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Drilling through a stucco wall is simple enough. Simpler if you get the right drill bit for the job.
You will also want wire shields on both ends of the wire to avoid abrading it on rough edges.
Note the hole in the bit for pulling the wire back through the hole, far easier than trying to fish it through after you have removed the bit.
First hits to get you a picture, shop around.
https://www.amazon.com/Bosch-BH2003T-18-Installer-Bit/dp/B00L2592OM/ref=sr_1_6
https://www.amazon.com/Through-Bushing-Insert-Protector-Wire/dp/B00UD076EK/ref=sr_1_5
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.