Hello I have a connect:amp s2. I have had it previously connect to my system and it worked fine. I recently change out some components and removed all of the S2 amps. I want to now add one back in and it will not go past the press the button on your connect:amp page. The button press is never recognized.
I have read of a couple of instances of this happening but did not see any resolution to this issue, anyone run into this?
Best answer by Pools-3015
Have you tried connecting the amp directly to your router? If that does not work, I would calling support. They have tools to troubleshoot problems better that we can here.
+17Have you tried connecting the amp directly to your router? If that does not work, I would calling support. They have tools to troubleshoot problems better that we can here.
Have you tried connecting the amp directly to your router? If that does not work, I would calling support. They have tools to troubleshoot problems better that we can here.
Then it doesn’t reconnect to wifi after removing ethernet.
+17Have you check for firmware updates while connected with a cable?
Have you check for firmware updates while connected with a cable?
It was fully updated just a couple of weeks ago when I had previously connected it
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.