Hello,
I am considering adding a Sonos Connect (not Connect AMP) to my Sonos setup at home.
It should output using the analog RCA to a pair of ROKIT 4 G3 (http://www.krksys.com/krk-studio-monitor-speakers/rokit/rokit-4.html)
I was wondering if it would work? I know that the Rkit is powered, but the Connect is meant to be attached to a receiver and not directly to speakers.
Any idea?
Thanks
Question
Sonos Connect (Not Connect AMP) and ROKIT 4 G3
+2This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
+21Cannot see any issue, just a case of getting the Phono to XLR cable and then using the varible output setting on the connect so you have a volume control.
Quite a few users on here have powered / active speakers.
Quite a few users on here have powered / active speakers.
+2Thanks Belly M,
actually the ROKIT 4 G3 has both Phono and XLR input. My idea is to connect my sound card (used for music production) to the XLR input and Sonos Connect used for music listening and extra Zone to the Phono input.
I will get the both and give it a try
actually the ROKIT 4 G3 has both Phono and XLR input. My idea is to connect my sound card (used for music production) to the XLR input and Sonos Connect used for music listening and extra Zone to the Phono input.
I will get the both and give it a try
The phono input is probably expecting differe3nt signal levels than your Sonos will be sending as well as containing some signal equalization circuitry that you don't want.
https://infogalactic.com/info/RCA_connector#Phono_input
https://infogalactic.com/info/RCA_connector#Phono_input
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.