Sonos v2 connect not working? Well I thought mine was either faulty or otherwise completely bricked. It would not reset. There was no green light, however hard I tried to reset it.

I disconnected reconnected via Ethernet to my router. I pressed the play and vol+ buttons a few times. Eventually the Sonos app picked it up, but again still not working , I had to give it a few goes. Eventually the Sonos app picked it up successfully.
 

Whilst the Sonos connect device  didn’t appear in the app as a registered device, the app then indicated it was performing an update. All my other Sonos products subsequently disappeared from the app as my registered devices. I left it 5 mins then the Sonos app prompt me to disconnect power from the connect, which I did , I then reattach to power whilst still connected  to Ethernet and the app indicated it was continuing with the update and setup process.  I subsequently had to rename it, as if from new. The app eventually then started to show all my other Sonos products after a short delay.

I reconnected the connect amp to my turntable. I had to wait a minute or so for the flashing white light to go solid but now all OK when connected via wi-if.