I have some ribbon speakers and they are 4 ohms . Will the new connect amp work well with these or will it be just OK
Page 1 / 1
The spec for the Amp is as follows...
The speakers’ power rating should be at least 125W for 8 ohm speakers, and at least 200W for 4 ohm speakers.
Do not connect speakers rated at less than 4 ohm.
Note: The new Amp can drive speakers with nominal impedance above 4 ohms. Two pairs of 8 ohm speakers wired in parallel are also supported. But do not wire your speakers in series because it will result in poor sound quality.
The speakers’ power rating should be at least 125W for 8 ohm speakers, and at least 200W for 4 ohm speakers.
Do not connect speakers rated at less than 4 ohm.
Note: The new Amp can drive speakers with nominal impedance above 4 ohms. Two pairs of 8 ohm speakers wired in parallel are also supported. But do not wire your speakers in series because it will result in poor sound quality.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.