I’m trying to connect my onkyo system (housing analog cd, phono, aux inputs) so that it provides a single output to the Sonos port…
can this be done?
Answered
How to Connect Onkyo TX-NR696 output with Port input
Best answer by ratty
There doesn’t appear to be tape in/out on that receiver. Such concepts must be too ancient for it.
You should use the Line Out (Zone 2). There may be configuration required to enable those jacks.
Edit: See p45 et seq of the manual.
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
In general, connecting the Sonos Port to a free tape loop would be advisable. I am not familiar with your specific device, however.
Thanks both- I tried Zone 2 line out, but it doesn’t seem to work.
I’ll try the free tape loop- need to get the right analog adaptor
thanks again!
There doesn’t appear to be tape in/out on that receiver. Such concepts must be too ancient for it.
You should use the Line Out (Zone 2). There may be configuration required to enable those jacks.
Edit: See p45 et seq of the manual.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.