I had posted earlier about connecting my vintage record player to Sonos and was given the exact information I needed and was able to get that done. Now that I have done this I notice the speaker volume is not terribly high like if I were just streaming music to my speakers and not going through the connect. I was wondering if I could add something to my system to give more volume? would I add an amp or something else?
Again, not terribly savvy with this stuff and any help would be appreciated.
Best answer by Ken_Griffiths
If not tried already, perhaps try changing the Connect’s line-in "source level" to a higher value … see this Sonos Support link:
https://support.sonos.com/en-us/article/adjust-line-in-settings
Set the level as high as you can, so that you do not hear any distortion at/near full volume level.
If not tried already, perhaps try changing the Connect’s line-in "source level" to a higher value … see this Sonos Support link:
https://support.sonos.com/en-us/article/adjust-line-in-settings
Set the level as high as you can, so that you do not hear any distortion at/near full volume level.
Ken,
Thank you - I did not know this. I will look at t his and report back.
Mike
Ken, thank you and that worked! I set it to 5 - it was on 2.
Seems to be much better now.
Thank you again
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
