Sonos Port 12V Trigger for Pioneer Receiver

I’m not sure that this device would work with modern receivers. As a test, simulate this device by simply unplugging the receiver from power, then reconnecting the receiver to power. Does the receiver then do what you expect?

Another point to consider is that modern receivers often have an internal memory backup battery. The memory saves setup information and current settings, such as Volume and radio station presets. Normally, this battery is bypassed (no energy is drawn from the battery) while the receiver is plugged-in to power and these batteries will last for many, many years. Using a device that disconnects the receiver power will slowly discharge the battery and reduce its lifespan. Full disclosure: I don’t know if your receiver uses this scheme.

As a science project, you could use a small computer, such as a Raspberry PI, to send Power commands to the receiver based on PORT’s 12V trigger. Of course, the practicality of this project depends on your experience. This could be a one or two evening project or an enigma.

ARDUINO fans could use this project as a base for developing a controller by adding an input for the 12V trigger.