Contributor I

Dead Play:5 need schematics or tips

208 replies
59724 views
Translate All

Hi

Play:5, manufacturing date sometime around 2009, is completely dead. No light in LED.

Found several cases of this online, but no solutions.

Does anyone have any knowledge about the problem, og better yet, schematics..

I mainly suspect problem in switch mode power supply. Have only done very basic measuring, but I find 220VAC on primary side, no power on secondary side. I think about ordering a mosfet, and/or a diode I suspect, but if I had schematics I could do some more pinpointing..

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

Show previous replies

S

Shamudi

Trending Lyricist I

I bought the box as defective because one of the antenna connections was break off. After I soldered it on, the lamp flashes red after the reset. Then I found out that the component was defective. I thought it was that capacitor. Or why could the lamp still blink red?

Translate

T

timc995

Prominent Collaborator I

I bought the box as defective because one of the antenna connections was break off. After I soldered it on, the lamp flashes red after the reset. Then I found out that the component was defective. I thought it was that capacitor. Or why could the lamp still blink red?

If it is flashing red (and not amber), then that would indicate a bad boot-up. This is usually due to a bad flash (either the chip has physically failed, or the contents are bad due to a failed upgrade). Unfortunately, your device is probably not repairable.

Translate

S

Shamudi

Trending Lyricist I

Wenn I connect the Box per LAN, i works all good. But after a Reset, the Box is flashing red. So I think, it couldn't be an bad chip. The Box do the Updates and everything, and after the connect per LAN, Iran pairing it per wifi in the setting.

Translate

T

timc995

Prominent Collaborator I

Wenn I connect the Box per LAN, i works all good. But after a Reset, the Box is flashing red. So I think, it couldn't be an bad chip. The Box do the Updates and everything, and after the connect per LAN, Iran pairing it per wifi in the setting.

That’s helpful. It could be that the WIFI module is bad, if you can’t get it to connect over wifi. (and I mean something bigger than just a bad antenna connection). You can try to swap a wifi card from another sonos device and see if that helps. The play:5, connect, and connect:Amp all use the same wifi module (stay away from the older ZP80s - they are not compatible).

Translate