Skip to main content
Contributor I
Mar 22, 2023 8:32 PM UTC
Answered

Changed to Eero Mesh, need to need to integrate Sonos

I have an existing cable router/modem. When I added the Eero mesh to extend my wi-fi range I had to identify the Eero with a different name. My iphone now defaults to the Eero wifi, but Sonos only recognizes the old wi-fi, so I have to toggle between two wi-fis to activate my Connect units. Sonos chat and a Sonos tech guy gave me no solutions. The Connect units are wireless. Any ideas ?

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
FredBinNCAnswer
Contributor I
Mar 28, 2023 12:45 AM UTC

Many thanks all. I was able to put the Eero mesh into Bridge mode, and that solved the issue. 

5 replies

Stanley_4
Grand Maestro
Mar 22, 2023 9:11 PM UTC

Sonos devices and Sonos controllers normally must be on the same LAN.

Maybe move Sonos to your new WiFi (read about issues with that here) and disable your old WiFi. Might want to set your old cable modem to Bridge mode at the same time to simplify things.

Translate
bockersjv
Local Superstar
Mar 23, 2023 10:15 AM UTC

I did this a few months ago.  I’m in the UK and have Virgin Media Fibre Broadband.  Their router is rubbish and even with setting up access points there we blackspots in and around my house.

 

Rather than run two WiFi’s I changed the Router/Modem to run as a Modem only.  Then added the Eero System as the Router and WiFi.  I set the Eero SSID and Password to the same as my, now redundant Virgin wifi settings.  Power cycle of every device, including the the Eero and old Virgin router and all is running well.  Eero now manages all the IP settings and admin of my LAN.

 

Works very well and I now have WiFi 6 too.

Translate
FredBinNCAuthorAnswer
Contributor I
Mar 28, 2023 12:45 AM UTC

Many thanks all. I was able to put the Eero mesh into Bridge mode, and that solved the issue. 

Translate
Lyricist I
Mar 29, 2023 9:00 AM UTC

I had the issue with old SONOS one products. Added TP-Link S7 mesh around the house, new network name. All my old SONOS controllers were wired so i presumed they would pick up the new network, but didn’t. Luckily the TP S7 mesh unit has 3 RJ45 outlets. plugged 2 of the controllers into this and the others then picked up the network.

Had to also set the mesh units to access / extender units 

It took a few hours to sort it out but all seems to be working well now 

Translate
106rallye
Mar 29, 2023 10:32 AM UTC

This will happen if you put two routers in the same network - devices on one network will no “see” devices on the other network and vice versa.

Translate