One of my zones uses a Connect and a 2 channels of a Emotiva UPA-7 power amp to drive NHT Absolute Zero speakers and 10d Sub.
The other 5 channels of the UPA-7 are driving my HT 5.1 setup and triggered by the Denon 3312-CI.
How can I trigger the UPA-7 when using the Connect zone?
Page 1 / 1
Had a chat with Emotiva regarding triggering the UPA-7 via the Connect and tech didn't know if it could be done since the Connect does not have trigger port.
Any suggestions on using the Connect with only a Power Amp and speakers?
Any suggestions on using the Connect with only a Power Amp and speakers?
I've done the reading and it looks like the only solution for my setup is to leave the UPA-7 powered on all the time (not triggered by either the Denon or Sonos).
Wish Sonos would put a 12V Trigger on the Connect! Seems a request for this goes way back...
The NHT speakers I'm driving are not very efficient so they require about 100W/ch of real power even when playing at modest levels.
So, if I'm not willing to leave the UPA-7 powered 24/7 and the Connect:AMP doesn't have enough power:
What amp's are people using with the Connect these days that will auto-sense and/or trigger?
Wish Sonos would put a 12V Trigger on the Connect! Seems a request for this goes way back...
The NHT speakers I'm driving are not very efficient so they require about 100W/ch of real power even when playing at modest levels.
So, if I'm not willing to leave the UPA-7 powered 24/7 and the Connect:AMP doesn't have enough power:
What amp's are people using with the Connect these days that will auto-sense and/or trigger?
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.