Skip to main content
Contributor I
Jun 22, 2015 10:45 AM UTC

Line in problem - sound cutting out intermittently

I've seen this question a few times, but cannot find a solution and would like my system checked out. I have a Connect, SUB, and three PLAY:5's. The system is set up to have 3 groups, and I run them connected to one another 90% of the time. I have no issues with the services or other inputs, however, my TV and streaming inputs are a hit-or-miss thing. When I last moved, I upgraded my internet signal and speed to be at 100mbps and I have connected the CONNECT with ethernet directly to the modem/router, so that shouldn't be an issue. I have line in coming from either the TV or from the cable box. In both cases, every once in a while, I get a garbled/cutting out of the sound. It recovers, but it is extremely annoying. I have to keep it on Automatic to have a decent watching experience, as if i change compression, the lip sync is terrible. I sent some diagnostics to the support team and have usage data on, so im hoping you can see that information and make an assessment. my last diagnosis send was confirmation number 4663215. I've tried using wireless with the connect, using different AV wires, plugging into PLAY:5s directly and bypassing the CONNECT, changing wireless channels (although if there's a trick to this specifically based on my new wireless system, and even using a separate receiver! ( please check the wireless signals? out) and multiple input sources. In my old place, I gave up on it. I thought I had it hooked up in a way to be able to enjoy it, and it works most of the time, but now has begun clipping and dropping all the time and I have to turn it off until I get it fixed because it is so frustrating. Please let me know if there's something im missing or if I need to sell the CONNECT and get a playbar, or whatever the best solution would be. I just want to be able to watch cable or ROKU without the sound dropping. Love these products, but this one problem is a big bear.
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

69 replies

Lyricist III
May 11, 2017 4:13 AM UTC
I am also having trouble with line in on a CONNECT. The device is brand new (48 hours out of box). Updated with the latest software on setup. Today was the first day that I had time to really use the device. A friend and I tried to play a video game on his PS4, but intermittently the line in port on the CONNECT would cut out and play no sound for anywhere from a half minute to a couple minutes at a time. Sometimes it would recover on its own, and sometimes I would fiddle with the Sonos app to try to get it to play again before it had a chance to recover on its own.

The setup is as follows:
IN: TV (older) headphone port wired into CONNECT Line In with SONOS provided 3.5mm to RCA cable.

OUT: CONNECT Line Out connected to a receiver driving two wired speakers and a sub with a standard RCA cable (red-white male connections on both ends)

NETWORK: Wired connection to router going into the CONNECT (router is upstairs, CONNECT is downstairs) AND a wired connection from the CONNECT to a PS4

SETTINGS: Line In Level = 10, Autoplay enabled, Line Out Level = Variable

I know that the device has Internet connection because it is passing the Internet connection on to the PS4, and a network test on the PS four proves that there is good connection. I do own more Sonos devices but for the sake of this issue we can ignore them because I am not trying to stream the line in two other Sonos devices. Streaming music on the CONNECT seems to work OK, but passing the input from the line in to line out randomly cuts out. I cannot fathom a condition where network would have an impact on connecting the line in to the physical line out on the device, and for the purposes of this issue we can view the CONNECT as being a fancy passthrough device inserted into the middle of a cable directly from the TV headphone port to the receiver. If I remove the CONNECT and use RCA splices to create a continuous cable, the sound passes from the TV to the receiver without interruption (and this direct wiring setup has been working for months with no issue). So I would like to know why the CONNECT is deciding at random to "break" the connection? It troubles me that a brand new device, (not an inexpensive one I might add) whose sole function in life is to take audio from a source (either physical line in or stream) and output the same sound on physical line out, is malfunctioning between the physical connections.
I can send diagnostics tomorrow if required.
Also, can someone explain to me exactly what the Line In Source Level Setting does? What is the meaning of the level distinctions?
Thanks!
Translate
JTM79
Contributor II
May 11, 2017 4:22 AM UTC
I have the same problem. In my case, all of my Sonos are wired.

I connect my phone to the Line-In jack on Sonos:5. Start playing music on the phone.
The Sonos:5 sounds fine.
The Sonos:3 will play 2 seconds of music, then skip one second, then play two seconds, then skip one, ...

It'll drive you crazy 😠
Translate
Keith N
Sonos Staff
May 11, 2017 4:34 AM UTC
@dakotalazenby - Welcome to the Community! Sorry you're having trouble with the CONNECT. It sounds like submitting a diagnostic report would be great, especially while we are passing PS4 audio through the TV.

I'd also check the audio from the headphone jack on the back of the TV while passing PS4 audio through the TV as well. We want to check the full signal flow at every possible break point.

Thanks in advance.
Translate
Keith N
Sonos Staff
May 11, 2017 4:38 AM UTC
I have the same problem. In my case, all of my Sonos are wired.

I connect my phone to the Line-In jack on Sonos:5. Start playing music on the phone.
The Sonos:5 sounds fine.
The Sonos:3 will play 2 seconds of music, then skip one second, then play two seconds, then skip one, ...

It'll drive you crazy :@


I can imagine, that would drive me crazy. Sounds like there might be some wireless interference cause some headache. Submit a diagnostic report, reply with the confirmation code it gives at the end and we can take a look. Here's how.
Translate
Lyricist III
May 11, 2017 1:32 PM UTC
@Keith N thanks for the prompt reply! I will send a diagnostic report as soon as I have a chance to sit down and play PS4 again. My simple tests when I inboxed the device didn't yield the cutting out problems. Only after some extended use (more than 15 minutes continuous) did it start to cut out every 10 to 15 minutes for the duration of (on average) one minute.

Until then, I am not sure what I can test. As I stated in my (albeit lengthy) post above, when I take the line from the TV headphone jack and splice it directly to the line into the receiver, the sound quality and signal is fine (same as it has been for months of lengthy use when it was one continuous cable. The ONLY difference in the setup now as opposed to before is that (effectively) I cut the cable in two and inserted the CONNECT into the middle of the cable from TV to receiver. See photo attached. This being the case, I have no reason to believe that audio from PS4 to TV or TV to the Line In port is at fault, since I can jumper out the CONNECT and get the (primary) desired result.
Translate
Tyler M
Retired Sonos Staff
May 11, 2017 7:58 PM UTC
dakotalazenby,

Thank you for the topology diagram. We'll definitely want to take a look at the diagnostic first but would like to clarify something on the cable. You said it used to be one continuous cable that was 'cut', did you physically cut it and splice new connections to the ends?
Translate
Lyricist III
May 12, 2017 1:52 AM UTC
No, haha! Using the word "cut" was simply to elaborate the point that the only change to the previous setup was injecting a CONNECT device into the middle of what used to be a continuous connection. I am now using the cables provided with the CONNECT (3.5mm to RCA and RCA to RCA) to make the connection path.

Being Mother's Day weekend, I am going out of town and will not be able to test the device immediately but I will plan to give the device another endurance test Monday and post diagnostics then. Thanks you for continuing to look into this issue.
Translate
Lyricist II
May 21, 2017 11:14 PM UTC
The audio has been dropping out from my system and is getting worse. I have 4 x play 5s and a Sub played via a Boost set up which is hard wired into an Apple Express (wired extension of my router). I am running 70-80 mbps now and was running on 6 Mbps but the dropping out is worse since the broadband speed has improved! I thought that would fix the issue as I thought it was due to buffering. It has been dropping out on Sky too. I use my set up to watch TV with the TV headphone socket wired a Sonos speaker (Line in). The sound dropping does not seem to be an issue with listening to music from the phone or streaming but just via the TV. I have had issues of latent sound ie not in time with the video/lips moving.

I have sent a diagnostic - 7419496. I hope this helps.

The Sonos boost, Apple Express, Apple TV are by the TV and 2x front Play 5s. From reading some posts I fear it may be interference. I don't know how to change the fibre settings but I am Level 2 AV on line in source and channel 11 Sonos net channel (should this be channel 6?). I appreciate any help or suggestions to rectify this matter and improve the sound.

Best regards
K
Translate
Tom B
Retired Sonos Staff
May 22, 2017 10:45 AM UTC
hey kdr2566, welcome to the community. What you're doing there is something the speakers were not really designed to do. You've got a first-gen PLAY:5 trying to broadcast a completely uncompressed analog audio stream to four other players over wireless. This is pushing the limits of what that player can do, and what 2.4GHz technology is capable of. This is why our home theater setups all use 5GHz to communicate. We can try to clear up some of the interference you have there, but to be honest it's not far off perfect already and any improvement will be incremental. You could enable some audio compression in the advanced settings of the app, but this will add more lip sync delay. If your TV has any settings which might allow you to compensate for this, then that will be the easiest fix. Otherwise, you might have to connect them all up with Ethernet cable which will be a basically perfect connection.
Translate
Help others find useful content by clicking the like button and selecting the best answer to your question
Lyricist II
May 22, 2017 6:15 PM UTC
Thanks Tom. I changed the to channel 6 from 11 which seemed to help or is that not connected to this issue?
I appreciate this is not an ideal set up but I guess it is good to hear that the wifi interference is minimal. I could connect the two front speakers by Ethernet to the switch box but not the sub and rears because they are too far away.
I was chatting to Emily in the sales chat re the sound bar, which I thought may complete the system, but my Sony TV is 6 years old with no optical output. Can I connect the sound bar any other way? Thanks again
Translate