Had difficulty connecting our brand new Connect. Finally got it set up via the Ethernet but it immediately needed to update. Error message 803 received. Unable to update. Any helpful info?
Answered
error Message 803
Best answer by RStock521
I ended up messaging support on Twitter. They had me run a diagnostic, then sent me a unique link to change some setting and force the update. Fixed my issue.
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Try a manual update. Try these hints https://support.sonos.com/s/article/2382?language=en_US which includes manual update I mentioned.
Cheers!
AjTrek1 wrote:
Try a manual update. Try these hints https://support.sonos.com/s/article/2382?language=en_US which includes manual update I mentioned.
Cheers!
Error code 803 is not included in that list. I’m having the same issue with my (new to me) Play 5 Gen 1.
That’s true error 803 is not listed. In my post l meant that you should try a manual update. The link was for further reference.
I ended up messaging support on Twitter. They had me run a diagnostic, then sent me a unique link to change some setting and force the update. Fixed my issue.
1 person likes this
I bought a used connect online and was triggering the error code upon setup. I was able to fix the issue by unplugging all units except for the new (to me) Connect that would trigger the error. With that being the only unit on the system, the update went thru. Then plugged back in all the other units including a sub, playbar, 3 Play 5’s, 10 play 1’s and 2 more connects. System works as should now. Hope this helps.
Correct, it requires a specific update for your individual device/software rev. There isn’t a generic manual update.
Gnudog got it right. Start your system, connect your new unit, take everything else off the system, and it will update the new unit. You still may have to try a couple of times to get the new unit to connect, but from there the system takes over.
RamLaFam wrote:
Had difficulty connecting our brand new Connect. Finally got it set up via the Ethernet but it immediately needed to update. Error message 803 received. Unable to update. Any helpful info?
I had the same problem adding a Sonos 5. App told me Sonos 5 needs an update. When I ran the update I got the failed notice. More info showed error 803.
I fixed it by turning all the other Sonos devices off and did the update again. This seemed to work for me. I then turned all the others back on and so far so good.
Hope that helps.
Ben
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.