Skip to main content
Avid Contributor III
Nov 28, 2022 2:35 PM UTC
Answered

Roam - On-line, then off-line. Lather, rinse, repeat.

I honestly do not understand what is wrong with my Roam. I have a pair of Play 1 speakers and a Connect:Amp, and none of them have the problems that the Roam has. 

The Roam is constantly falling off of the network. It disappears for weeks at a time, then returns and says it is off-line. How does the system know it’s there if it’s offline? A power cycle on the Roam and a reboot of the router help briefly, but then the problem returns -- the Roam has roamed away somewhere. 

I get that 2.4 GHz signal interruption and constrained bandwidth may cause connectivity glitches, but neither the Play speakers nor the Connect Amp have a problem adjusting to this. I have moved the Roam to the same room as the router, and it doesn't help. Also, I have not changed any router settings. 

It is seriously frustrating and infuriating to be forced to diagnose this problem every time I want to use the Roam. Other Sonos products just work, and work well, which is one reason I opted for the Roam as my third Sonos purchase. 

The Roam has not delivered on its promise of service and I am tempted to send it back to Sonos for a refund. It’s too late for that of course but this experience has me seriously reconsidering the Sonos experience. 

Is there anything I can do to prevent this poor behavior? 

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
edge306Answer
Trending Lyricist II
Nov 29, 2022 8:49 PM UTC

Hmmm…. set the Roam to a fixed IP address in the network mesh (and a new Beam also added last week), as I’d done already with the rest of the Sonos kit in the house.  Roam was rebooted and is showing as now linked with the new, fixed IP.  Since then (several hours ago), it’s remained online and connected, despite not being used to play anything.  MIght be worth trying, if you’re having the same problem…???… (Battery Saver & WiFi Power Save also both still turned off in the app, and the Roam is sitting on the charger base which is plugged in and switched on)

16 replies

Rex BlockAuthor
Avid Contributor III
Nov 30, 2022 4:43 PM UTC

set the Roam to a fixed IP address 

Interesting. Can this be done on a non-mesh network?

 

Yep.  You can assign fixed IP’s to attached devices on any network.  You will likely have to reboot the network and device after doing so but then any time after that, your router should assign the same IP address to that device.  I’ve assigned fixed IP’s to all of my Sonos kit (and much else too!), makes for a more organised system...

 

Excellent. I assume that’s done through the router admin console (192.168.1.1), right? So I am in there and I see several Sonos devices. Ignoring the ones connected by Coax, there is a SonosZP (802.11n), plus a couple of other SonosZP’s connected by Coax.

I suppose I could shut off the Roam and see which one disappears or goes inactive ….

 

Translate
Trending Lyricist II
Nov 30, 2022 5:40 PM UTC

You can check the IP addresses of each speaker in your Sonos app. Its in Settings somewhere I'm out now so can't say exactly where...

Translate
Rex BlockAuthor
Avid Contributor III
Nov 30, 2022 5:44 PM UTC

You can check the IP addresses of each speaker in your Sonos app. Its in Settings somewhere I'm out now so can't say exactly where...

Settings → System → About My System

scroll down

Thanks for the nudge! 

 

Translate
Trending Lyricist II
Nov 30, 2022 6:07 PM UTC

That's it... so you can match the MAC address and IP which will be in the router settings and the app. Look for something called Address Reservation or similar in the router admin, that's where you can reserve specific IP addresses for devices using the MAC addresses...

Translate
Rex BlockAuthor
Avid Contributor III
Nov 30, 2022 6:41 PM UTC

Thanks again. I’ve set the ROAM to a static IP to see if that doesn't clear up the problem. I am in a building providing Internet for three separate households and it gets really busy in here sometimes, with so many people at home and increasingly more devices on the network. 

One thing this exercise has done is prompted me to really get a handle on the network (I am the admin) because the downstairs residents are frequently complaining about it, and I don’t want to call Verizon for every little thing. 

I consider this closed (unless the ROAM wanders off again). Thanks everyone.

 

Translate
Airgetlam
Nov 30, 2022 6:51 PM UTC

Note that for most routers, duplicate IP addresses do not show up in the DHCP table. All the DHCP table shows is what is connected at the moment you access it, and most don’t show changing connections over time. 

For general consumption, not a specific reply to this situation. :)

 

Translate
Bruce