Skip to main content
Contributor I
Jun 4, 2024 2:03 PM UTC

optical audio cable

I have a brand new ray, and I followed the instructions and hooked in the optical audio cable to the back of the ray and into the audio output on my TV. I’ve been try to use the app to have it read that particular thing and it won’t read it, and I can’t therefore set up my, remote control to control the sound. I’ve unhooked and re-hooked it several times and yet I still can’t figure out what else I might need to do to get it to work. Any recommendations would be helpful. I’ve been on hold with the Sonos technical support for an hour now.

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

14 replies

106rallye
Jun 4, 2024 2:49 PM UTC

Not sure what you mena by “I’ve been try to use the app to have it read that particular thing and it won’t read it“. What should read what?

Translate
Prodigy III
Jun 4, 2024 2:54 PM UTC

@Lizzya 

Did you first add the Ray as a new speaker in the Sonos app?

Home  →   Settings (cog)  →   +Add Speaker or Component

Translate
LizzyaAuthor
Contributor I
Jun 4, 2024 2:55 PM UTC

Hi. Sorry about that. In the app when you go into TV set up, it’s trying to read the optical audio cable, which I Believe I have set up correctly. The app doesn’t seem to want to find it and without that it doesn’t seem that I’m able to connect my TV remote so the only sound I’m getting is still out of the TV not out of the beam.

Translate
LizzyaAuthor
Contributor I
Jun 4, 2024 2:58 PM UTC

I am confused about what you mean by speaker but I’m trying to just set it up as a simple sound bar with my TV. Does this answer your question?

Translate
jgatie
Jun 4, 2024 2:59 PM UTC

Check both ends of the optical cable.  There is a very small cap on the end that needs to be removed for the signal to get through.

Translate
Prodigy III
Jun 4, 2024 3:02 PM UTC

I am confused about what you mean by speaker but I’m trying to just set it up as a simple sound bar with my TV. Does this answer your question?

To set up a Sonos soundbar, you need to add it to the Sonos app via the instructions I provided. Then follow the instructions in the app. 

Also check the optical cable is fully connected with the cap removed, as @jgatie has advised. 

Translate
LizzyaAuthor
Contributor I
Jun 4, 2024 3:18 PM UTC

All, thanks for the information on the tab on the optical cable. I pulled those, but it’s still not connecting through the TV set up on the app. I have to run out now, but I will reach out to you guys again later this afternoon. Really appreciate you trying to help.

Translate
Airgetlam
Jun 4, 2024 4:45 PM UTC

Just as a comment for later consumption, some TVs have an audio setting switch to turn on/off the optical port. 

Translate
Bruce
LizzyaAuthor
Contributor I
Jun 4, 2024 4:49 PM UTC

Where would I look for that?

Translate
Enthusiast I
Jun 4, 2024 4:53 PM UTC

Where would I look for that?

Most likely in the audio menu to the tv. Put the make and model on here and I’m sure someone on here will help.

Translate