I’ve restarted and added my Beam three times, and continue to see this message. After powering it off and on again, it never appears in my Sonos app. This is beyond frustrating!
Best answer by Corry P
View originalI’ve restarted and added my Beam three times, and continue to see this message. After powering it off and on again, it never appears in my Sonos app. This is beyond frustrating!
Best answer by Corry P
View originalHi
Welcome to the Sonos Community!
It looks like a communication issue between your controller device and your Beam.
I recommend you first turn your WiFi router for at least 30 seconds, then turn it back on and wait for WiFi to return before trying again.
If you have any devices that extend the range of your WiFi, I recommend a read of my troubleshooting article:
Finally, it may be a case of electromagnetic interference near either the router or the Beam. A read of our Reducing wireless interference help page should assist.
I hope this helps.
Hey! New here… had the same issue some minutes ago. On my case, it was solved by disabling “AP Isolation” on the Access Point’s configuration webpage. You may find more info and how to disable it on Linksys APs here: https://www.linksys.com/gb/support-article/?articleNum=135098
Good luck!
Pablo
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.