I’ve noticed that when playing PCM 5.1 the surround audio volume is quite low but when playing Dolby Atmos surround audio volume is loud. My current solution is to manually adjust surround audio to +7 or +8 when playing PCM 5.1 then reset to default settings when playing Dolby Atmos. It would be really nice if we could have codec profiles that would allow us to save custom levels per audio codec.
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
You are lucky to have surround sound. I have not been able to use my 2 Era300’s since the firmware update….
mikecollins99 wrote:
You are lucky to have surround sound. I have not been able to use my 2 Era300’s since the firmware update….
That’s disappointing to hear. I’m temporarily using Era 100s but am planning on upgrading them to Era 300s in a few months.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.