Skip to main content
Contributor I
Apr 12, 2022 1:38 PM UTC
Answered

Play 5 Gen2 L+R+Sub(Gen3) - line-in via TV music heard but no voice

Before I separated my wifi mesh to stop band steering, I could use my Play 5 Gen2 L+R stereo and Gen3 sub to watch movies from line-in via the tv and listen to music although, the sub would usually appear as a “?”. When I used trueplay, the music would play for about 5 seconds, then the sub would stop working, followed by the right speaker and the sub would disappear from the network.

After 3~4 hours on the phone with Sonos, I arrived at separating the wifi to 2.4 and 5 Ghz and placing the speakers all on 2.4GHz. The speakers now can trueplay, but now the line-in from the tv will only play the music track with no voice track.

Does anyone have any insight into resolving this or should I just factory reset all the speakers and start again?

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
ratty
rattyAnswer
Apr 12, 2022 1:47 PM UTC

The Line-In is just a stereo signal. It will play whatever it receives. There’s no way it could filter out the voice.

However if the 3.5mm jack isn’t inserted fully, such that the contacts aren’t correctly aligned, you could be hearing only part of the input signal. 

3 replies

ratty
rattyAnswer
Apr 12, 2022 1:47 PM UTC

The Line-In is just a stereo signal. It will play whatever it receives. There’s no way it could filter out the voice.

However if the 3.5mm jack isn’t inserted fully, such that the contacts aren’t correctly aligned, you could be hearing only part of the input signal. 

Translate
timtimAuthor
Contributor I
Apr 12, 2022 11:58 PM UTC

Thanks, I realised after moving things around I didn’t plug the cable fully in. derp.

Translate
Airgetlam
Apr 13, 2022 12:01 AM UTC

Happens to all of us at some point, don’t sweat it :)

Translate
Bruce