Need possibility of adding delay in addition to the normal 70ms

Most people who buy the Connect device do so to integrate SONOS with an EXISTING expensive multi speaker setup.  And who these days doesn't buy a surround sound receiver???  Most all of them perform processing which is the cause of the delay.

I've tried the suggested solution - Direct mode which improved the sync issues only slightly but in that mode, all I get are two speakers; left, right and the sub.  Forget the other two sets that I have in the system!

SONOS, you have marketed a device that by it's very definition is supposed to integrate these systems into the SONOS eco-system.  Your slogan that you so proudly display across your site needs some reconsideration!

"Warm, full-bodied sound that’s crystal clear at any volume. No skips, delays or drops. Perfect sync in every room."

However difficult this may be to code around based on a response further up this thread, you absolutely must address this.  How can you continue to sell the Connect knowing that it will very likely NOT be in "Perfect Sync" with any of your other rooms where you have SONOS devices?

This shouldn't be a wish, it's a glaring short-coming of the SONOS system as it stands today and it contradicts your marketing entirely.



Agreed Abel but if I put the Yamaha to 7 Channel I get excellent audio with an active Sub. I would prefer to use a Digital out and the price point of the Connect would suggest that it should work. I believe Sonos is somewhat complacent with their customer base as evident with the lack of DTS on the playbar, poor sync with the Connect and an app experience that is less than ideal unless your on iOS.

Most people who buy the Connect device do so to integrate SONOS with an EXISTING expensive multi speaker setup.  And who these days doesn't buy a surround sound receiver???  Most all of them perform processing which is the cause of the delay.

I've tried the suggested solution - Direct mode which improved the sync issues only slightly but in that mode, all I get are two speakers; left, right and the sub.  Forget the other two sets that I have in the system!

SONOS, you have marketed a device that by it's very definition is supposed to integrate these systems into the SONOS eco-system.  Your slogan that you so proudly display across your site needs some reconsideration!

"Warm, full-bodied sound that’s crystal clear at any volume. No skips, delays or drops. Perfect sync in every room."

However difficult this may be to code around based on a response further up this thread, you absolutely must address this.  How can you continue to sell the Connect knowing that it will very likely NOT be in "Perfect Sync" with any of your other rooms where you have SONOS devices?

This shouldn't be a wish, it's a glaring short-coming of the SONOS system as it stands today and it contradicts your marketing entirely.


What model of Yamaha do you have. If its in 7 channel mode, and you are getting sound through sub, you may have found the Holy grail of this thread. I agree with you that Sonos is not interested in accomodating any product that is not theirs. If I was Sonos marketing, I would want customers to be forced to buy more speakers. Not integrate with the ones the customer already owns. Problem is the Sonos speaker will never sounds as good as my B&Ws.

Most people who buy the Connect device do so to integrate SONOS with an EXISTING expensive multi speaker setup.  And who these days doesn't buy a surround sound receiver???  Most all of them perform processing which is the cause of the delay.

I've tried the suggested solution - Direct mode which improved the sync issues only slightly but in that mode, all I get are two speakers; left, right and the sub.  Forget the other two sets that I have in the system!

SONOS, you have marketed a device that by it's very definition is supposed to integrate these systems into the SONOS eco-system.  Your slogan that you so proudly display across your site needs some reconsideration!

"Warm, full-bodied sound that’s crystal clear at any volume. No skips, delays or drops. Perfect sync in every room."

However difficult this may be to code around based on a response further up this thread, you absolutely must address this.  How can you continue to sell the Connect knowing that it will very likely NOT be in "Perfect Sync" with any of your other rooms where you have SONOS devices?

This shouldn't be a wish, it's a glaring short-coming of the SONOS system as it stands today and it contradicts your marketing entirely.


He's stating in the comment the model, the question is if he hears music 5.1 or just stereo.

Same Problem with a Denon AVR-3313. The connect device is the first device from Sonos where I am not satified. From an innocvative Company like Sonus it should be no issue to implement that once in the connect device one time.

I would purchase 2-3 more play3s if sonos fixes this problem.  The sonos system is obviously able to implement a delay because the system is capable of a lipsync delay.

I have a very simple problem that prohibits me from adding my SONOS amp as a pair of rear speakers to my computer. My computer presently has two basic "front" powered speakers on my desk. My office SONOS amp is on my credenza behind me. I want to connect the computer's "rear" speaker jack to the Line In on the SONOS so that I can have surround.

When I did this the delay was almost 1 second because of the SONOS compression. So I turned compression off. The delay lessened, but not enough to eliminate the echo caused by the delay. I then fiddled with my computer's Realtek HD Sound driver to change the virtual distance between the rear speakers and this did not have enough impact to eliminate the echo either.

Assuming that the SONOS signal is processed by software that creates this delay, wouldn't it be possible to add a setting in the next firmware update to bypass the signal processing (for Line In  only) that creates any delay at all? This would allow anyone to marry a basic set of powered speakers with a second set of SONOS speakers with no echo.

Thanks

Any hint as to whether this is coming?  I know you can't promise a date or anything, but a "yes" it's in the top 10 or something would be good.

I would say it will never happen as it has been over 2 years and this issue still persists. Sonos know about it, I've even been messaged by them telling me to bypass the surround capabilities of my AV Receiver which completely misses the point of having a AV Receiver. I actually don't think they can implement a solution to this problem as if they could they would have done it by now! It is a shame because they have certainly lost further sales to me!

It is definitely technically possible and Sonos has to ability to implement it.  
1. The Playbar has a the ability to change the delay.  
2. I'm fairly certain that when the original Sonos speakers came out they HAD a delay feature that could be adjusted per speaker.  Someone more familiar with the history of the Sonos product line and software might want to comment.

On these forums Sonos and other posters repeatedly take this tone that 'blames' the receiver for the lack of sync. Nothing could be further from the truth.  No one component or manufacturer is to blame for the situation.  The problem is both the receiver companies and Sonos aren't taking care of their customer's needs.

Take a look at all these posts on the 'sync' issue.  There is a very real and compelling need for an audio system that meets the needs of both wired and wireless speakers while keeping the entire system in sync.  The reality is that most people have a receiver with wired speakers (typically theater or TV room and maybe in a few other zones) but also want the sprinkle more speakers throughout their home.

Why won't Sonos invest in this software tweak?  I'm pretty sure the delay option would just be a software update.  Unless they package the feature in a new device as a money grab.  I can only speculate.  From the outside it appears that the company wants complete 'control' of their audio ecosystem.  Kind of an Apple computers mentality.  To me it reads 'Our product is so fabulous people will adjust their entire audio systems to fit Sonos.'  

That's not remotely true for me.  Sonos has a cool business model and a neat product but there it has more quality competition every day.

I'm in the same boat as most people here.  I would buy between 3-4 more Play 3's if they had the delay feature.  I like quality audio but I like it more when EVERYTHING in my house is in sync.  

As it stands I'll stick with the one Play 3 I'm currently using.  While I haven't found the solution yet, when something better comes along that fits my specific needs (wireless speaker technology that can seamlessly integrate with my current wired system and stay in sync), I'll get rid of my one Sonos speaker and buy the more complete product.

I personally don't intend to invest any more in Sonos until they invest in me.

I think it would be in SONOS best interest to update us on this situation out of common courtesy. There's obviously enough people concerned with this problem that something should be addressed here in one way or another?

Thank You SONOS, your input would greatly be appreciated!