I am trying to run a mixed setup. I have a Sonos Play 5 and Sonos Connect in my living room that Id like to remain wireless and connected via wifi. My WIFI router is in the living room as well so there is a very good connection between the router and the 2 Sonos there. I have another Sonos Connect and a Sonos Play 5 in the bar on the other end of the house. The ones in the bar are hardwired because the wifi barely reaches there and I have problems when those units are connected via wifi. The Connect (bar) is wired to the router and the Play 5 (bar) is wired to the other port on the Connect. My goal is to have the 2 devices in the living room use WIFI, not SonosNet, and leave the Connect and Play 5 in the bar as wired. I can get it to work a little while that way by setting up the Sonos system to use Wifi and disabling the wifi on the Connect and Play in the bar. However, either the Connect or Play will turn back on the Wifi on it’s own after awhile. The 2 Sonos in the living room then connect to it with a poor connection vs using the strong WiFi connection they could.
When it is working the Connect and Play 5 in the bar are WM:0 and the 2 sonos in the living room are WM:1. However, after a few minutes the wifi will turn back on, on one of the 2 devices in the bar, and everything goes to WM:0.
What is going on? Why can’t I keep wifi disabled on the 2 connected devices?
Best answer by rattyView original