Long story short... I have the following, all home run, back to my office closet:
(4) CAT6 cables to each room in 1" conduit, (24) CAT6 cables total for A/V
(4) CAT6 cables to exterior of house in 1" conduit for internet
(4) CAT6 cables to each corner of the house in 1" conduit, (20) CAT6 cables total for security
(9) whole home audio zones with (18) speakers total, (16) speakers are in ceiling
I am not even sure exactly what I am trying to accomplish and I am open to suggestions. Currently, I am thinking of the following:
1. All A/V equipment located in the office closet (AppleTV, FireTV, etc...)
2. Modem located in the office closet
3. All security equipment located in the office closet
4. (9) audio zones with independently controlled volume. All zones can simultaneously share the same input and I only need (2) input sources... Sonos and TV. And I do not have wall volume controls installed.
I am looking for advice on:
1. How to neatly get all the wires through the wall and still have access to the conduit if I need to pull/replace wiring.
2. Should I go with a server rack or something else?
3. Do I just go with (9) Sonos Amps $$$, or is there a cheaper alternative... maybe a Sonos Connect and Multi Room Amp?
Question
Whole Home Wired Multi Zone Setup
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
