Skip to main content
Contributor I
Nov 20, 2026 1:24 PM UTC
Question

sonos system and speakers only work if connected via ethernet cable to rooter

I’ve had minor connectivity issues the entire time I’ve owned my Sonos products like most people but this is a new level. I recently moved house and set up a new internet provider. My Sonos system initially connected and worked but then very quickly lost connection on a daily basis and my established system would vanish.

Currently the only way my app recognises that I have an established system with 2 speakers is to permanently connect one to the rooter. The second I remove the Ethernet cable the whole thing disappears. Also every single time I manage to get it up and running again I’m told that each speaker needs a big update but it never fully finishes meaning I cannot register either speaker. 
 

I’ve done factory resets, made sure there’s not multiple systems or accounts attached to the speakers and also spend 2 hours on the phone with Sonos but with absolutely no solution offered. 
 

can anyone help?! The speakers are currently just expensive paper weights at this point. 

2 replies

Airgetlam
Nov 20, 2026 3:48 PM UTC

Probably best if you were to call Sonos Support to discuss it. Despite the two hours previously invested, getting a new rep (don’t talk to the chat bot) may help. 

When you speak directly to the Support staff, they have tools at their disposal that will allow them to give you advice specific to your network and Sonos system.

It sounds like there are several things going on, first being that your ‘rooter (sic)’ isn’t set up properly to match the data in the Sonos Network Requirements FAQ. It may also be that the firmware on the speakers is old enough to require a manual build to get them up to date, although I’ve never heard of a sequence by which they try, but don’t finish. Usually, if they report and try, they’re capable of updating. 

It’s also possible the speakers are experiencing wifi interference from outside your network, and your router requires a channel change, or the devices may need to be closer to the router. Again, this is data a rep could potentially ‘see’ in the system reports we don’t have access to. 

Translate
Bruce
Stanley_4
Grand Maestro
Nov 20, 2026 6:04 PM UTC

You could try this.

Turn off any filtering or blocking you have enabled on your router, also any VPN you have running.

Connect one speaker to Ethernet and power ONLY that speaker up.

Try the update. If it works, confirm your network settings in Sonos match your new router.

Power the speaker down, then do the same for the other speaker. 

Disconnect the Ethernet and power the speakers up, give them a minute to boot and connect.

If there are still issues:

https://support.sonos.com/en-us/article/connect-sonos-to-a-new-router-or-wi-fi-network

https://support.sonos.com/en-us/article/resolving-double-nat-issues

 

Translate