Skip to main content
Contributor I
Dec 24, 2022 7:35 PM UTC
Answered

Locking Sonos to 5GHz

Is it possible to force Sonos to use the 5 GHz band and thus avoid microwave interference?

I have recently replaced some old Sonos devices with new S2 capable devices, so I have a mixture of Sonos Five, Sonos Port (all new) and Play:3 (older, not replaced). Three of them are hard-wired to the LAN, the rest rely upon wireless.

My home WiFi network supports both 2.4GHz and 5GHz (same SSID) with two WAPs to provide good 5GHz signal throughout my house.

My problem is that when I use my microwave a number of the devices lose the music stream (which is coming from a NAS hard-wired to the LAN).  

This suggests Sonos is using 2.4GHz.  Is there anyway I can have the Sonos devices just use 5GHz all the time to avoid this issue?

 

 

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Airgetlam
AirgetlamAnswer
Dec 24, 2022 9:00 PM UTC

SonosNet, to my knowledge, is only 2.4Ghz, for both better wall penetration, and signal range. For streaming music, there just isn’t the need for larger and faster bandwidth. 

Yes, many people have chosen to use an unwired network, but if you’re unwilling to run two different SSIDs, there is no way to ‘lock down’ Sonos to use the 5Ghz signal, unless that is the only signal available. And the very oldest Sonos devices (like the PLAY:5 gen 1) don’t have a 5Ghz antenna. 

Bruce

12 replies

Enthusiast I
Jan 29, 2023 2:33 PM UTC

I recently upgraded to S2 and removed all legacy devices that could not be updated to the S2 platform. I only have (4) Play 1 devices using Sonosnet via the Boost, everything else is hard-wired. I unplugged (ac power) the Boost and Play 1’s then powered the Play 1’s up again but not the Boost, effectively forcing a WiFi connection and removing Sonosnet. My Play 1’s all reconnected to my Orbi Router (mesh system) at 5ghz.

Translate
Airgetlam
Jan 29, 2023 5:56 PM UTC

Note that RF interference is not exclusive to Wi-Fi (radio) signals only, it can affect/penetrate cables as well, depending on a wide variety of factors. Cabling your Sonos can help in most cases, but it’s not a silver bullet. 

Translate
Bruce