Skip to main content
Contributor I
Jan 3, 2023 12:33 PM UTC
Answered

i’m just about to launch my Sonos down the bottom of the garden

So I’ve got loads of Sonos all over a large house with WiFi extenders and it doesn’t work. I also have to have my Broadband from a local supplier as they have to beam it over fields etc. 

so unhappy with all my Sonos at the moment 

 

 

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
John BAnswer
Jan 3, 2023 10:30 PM UTC

There is a lot going on there, including plenty of scope for wireless interference.

Please would you wire that Playbar using the spare cable from the primary cube?  Give it a couple of minutes then in the Sonos app check in About My System.  All Sonos devices should show as WM=0, except for Move and Roam which should have WM=1.

Please see if that works OK.

There may be more we have to try.  Sonos works out the box for most people, but yours isn’t the most straightforward of setups, so it is to be expected that some work is needed to get the configuration right.

You mention the cameras working off different extenders, but the cameras don’t need to constantly communicate with each other in order to stay in perfect sync.  Sonos speakers do. All the cameras need is a path back to the router.  It’s a far, far easier process.

Edit: if any speakers that should have WM=0 still have WM=1, try just powering them off, wait 30 seconds then power back on.

24 replies

skullc
Prodigy III
Jan 3, 2023 10:29 PM UTC

@Jhster 

I have used 4g as my main broadband now using 5g if you have the option it's a good source for Internet all round

I still have my arc hardwired to the router via a switch and all my sonos are on sonosnet which is preferred 

Translate
Network= livewire cpe pro 3 +eero 6 pro wireless
John BAnswer
Jan 3, 2023 10:30 PM UTC

There is a lot going on there, including plenty of scope for wireless interference.

Please would you wire that Playbar using the spare cable from the primary cube?  Give it a couple of minutes then in the Sonos app check in About My System.  All Sonos devices should show as WM=0, except for Move and Roam which should have WM=1.

Please see if that works OK.

There may be more we have to try.  Sonos works out the box for most people, but yours isn’t the most straightforward of setups, so it is to be expected that some work is needed to get the configuration right.

You mention the cameras working off different extenders, but the cameras don’t need to constantly communicate with each other in order to stay in perfect sync.  Sonos speakers do. All the cameras need is a path back to the router.  It’s a far, far easier process.

Edit: if any speakers that should have WM=0 still have WM=1, try just powering them off, wait 30 seconds then power back on.

Translate
skullc
Prodigy III
Jan 3, 2023 10:34 PM UTC

Do you have 4g reception in your area?

Yes I do and it’s not bad

Not sure what providers you have but on three I was getting 80mb on average on 4g now getting 300mb on 5g 

And it was cheap 😊

Translate
Network= livewire cpe pro 3 +eero 6 pro wireless
JhsterAuthor
Contributor I
Jan 4, 2023 9:00 AM UTC

John B, will do this sometime today 

Translate