Skip to main content
Contributor I
Apr 13, 2017 10:52 PM UTC
Question

Connecting a turntable to existing Sonos Speaker network | Connect or ConnectAMP

I'm purchasing an Audio-Technica AT-LP120-USB turntable (with built in pre-amp). I have two Play 1's and a Play 3 -- and I want to be able to play to those speakers only (or any additional Sonos speakers I buy in the future) via the audio out on the turntable. I do NOT have any other audio equipment, such as an amp/receiver or other speakers. Is my assumption correct that I only need the Connect to play under these conditions -- or is the ConnectAMP needed?

Additionally, could I equally get a Play 5 (in place of one of the Connect productts) and connect the turntable directly to the Play 5 and still connect with the other speakers?

Thanks in advance.
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

12 replies

Lyricist I
Sep 5, 2018 9:46 PM UTC
Here's a question, is there a step by step guide to connecting a Audio Technica - LP120-USB turntmy existing able to an Onkyo TX 8020 receiver to my existing Sonos network?
Translate
jgatie
Sep 6, 2018 2:17 PM UTC
Here's a question, is there a step by step guide to connecting a Audio Technica - LP120-USB turntmy existing able to an Onkyo TX 8020 receiver to my existing Sonos network?

You would need a Sonos Connect. Connect the turntable to the Connect via these instructions:

https://support.sonos.com/s/article/1080?language=en_US

Note if you turntable does not have one, you will need a phono preamp.

Then connect the output of your choice on the Connect (analog, optical, coax) to the appropriate input on the Onkyo. This will give you the ability to play all Sonos sources on the Onkyo, as well as playing the turntable source on all other Sonos devices.
Translate