Hello, I’m trying to connect my Sonos Move speaker to my Project turntable using project Box E BT preamp, my other speakers connect to it, but I can’t seem to be able to connect the Move Speaker.
Wondering if someone could help me.
Answer
connecting Sonos Move to Project turntable using project Box E BT preamp
Best answer by GuitarSuperstar
Reboot the Move by following these steps:
- Take Move off of the charging base.
- Hold the power button for at least 5 seconds, or until the status light turns off.
- Wait 10 seconds.
- Press the power button or place Move back onto its charging base.
Then follow these steps to pair the Move with the Phono Box:
NOTE: I would disable Bluetooth on any other device near the Phono Box.
1. Switch Move to Bluetooth mode
Find the Bluetooth button located on the back of your Move between the Power and Join button. Press the button once to switch to Bluetooth Mode. Move will chime and the LED on top of the speaker will turn blue.
2. Enable pairing mode on Move
Press and hold the Bluetooth button to enable pairing mode. Move will chime again and the LED will flash blue.
3. Pair your device with Move
You will see a solid blue LED and hear a chime when the connection is complete.
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.