Skip to main content
Contributor I
Dec 18, 2020 9:35 PM UTC

Sonos not reconnecting

Is there a current bug or issue in the firmware / OS that does not allow non-wired devices to reconnect after a network outage without a power cycle? This has never been the case and I am seeing it with both older Play:1s and new One SLs as well as a Five. 

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

5 replies

Stanley_4
Grand Maestro
Dec 18, 2020 10:57 PM UTC

Long standing issue, nobody has managed to pin down where it is though.

Solution for most folks is to use the router’s DHCP to assign static/reserved IP addresses to the Sonos devices.

Translate
c.wanjaAuthor
Contributor I
Dec 18, 2020 11:23 PM UTC

Long standing issue, nobody has managed to pin down where it is though.

Solution for most folks is to use the router’s DHCP to assign static/reserved IP addresses to the Sonos devices.

How ‘long’ standing? I do not recall seeing this historically. But I cannot remember if I used static IPs in my old setup. Curious how that is solving the issue as well? 

Thanks in advance! 

Translate
Stanley_4
Grand Maestro
Dec 19, 2020 12:33 AM UTC

I don’t know. It was here in 2006 when I got my first few Sonos.

How much further back it goes I don’t know.

Translate
c.wanjaAuthor
Contributor I
Dec 19, 2020 3:11 PM UTC

I don’t know. It was here in 2006 when I got my first few Sonos.

How much further back it goes I don’t know.

Appreciate it. Will look at the static IPs. Thinking about putting the Sonos devices on their own VLAN anyways. 

Translate
Stanley_4
Grand Maestro
Dec 19, 2020 10:51 PM UTC

You’ll likely have to put your controllers on the VLAN too.

Translate