Skip to main content
AdamY
Contributor II
May 5, 2020
Answered

Sonos in Wall Surround Sound

Hi All, 

After some conflicting information I’m looking for some guidance.

 

Essentially I had planned 2 purchase:

2 x In Wall Sonos Speakers & AMP to power

2 x Sonos One

1 x Sub

 

I’d planned to set these up as a Surround Sound System, with the In Wall Speakers creating the Phantom Centre Channel, and the 2 x Sonos Ones being the rear left and right.

 

Apparently this can’t be done?

 

I don’t want to purchase a Beam or Playbar as the TV currently sits on a chimney breast and the wall is flush without plug sockets. I haven’t opted for the ceiling speakers either as I want a speaker as part of the surround sound setup to have Alexa built in I can group.

 

Any assistance before I go spending a few 1000 is great.

 

Thanks,

 

Adam

 

    This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
    Airgetlam
    AirgetlamAnswer
    May 5, 2020

    That should be doable. What makes you think it can’t be done?

    The challenging part will be running the HDMI cable from the TV to the Amp, but that’s not impossible, and could be easy. 

    Bruce
    View in thread

    13 replies

    Show previous replies
    AdamYAuthor
    Contributor II
    May 5, 2020

    The AV provider is wrong.  When you use a Amp for your front speakers, there is no requirement to use an Amp for the rear speakers as well.   You can use  pretty much any pair of Sonos speakers you want except Sonos Move, or a second Amp.

    Danny/Bruce, thanks so much for this.

    I had a small meltdown when told it couldn’t be done, as we’re currently having an electrician pull wires through the walls. 

    Another one, I hear that when the Sonos Ones are setup as surrounds Airplay is then disabled. I presume Airplay would still be enabled on the AMP for stereo to all 4 speakers?

    Thanks again.

    Adam

     

    That is correct.  For home theatre room, airplay is going to communicate to the ‘master’ speaker, which is the one that plays the front speaker channels.  So that speaker must be airplay enabled, and the Sonos Amp is. 

     

    FYI, the reason this issue comes up is that the current playbar is not Airplay compatible, so using Sonos Ones as rears with a playbar isn’t an airplay compatible room.

    Danny,

     

    Just reading back through the comments, what was your opinion of 2 x Front Wall Speakers acting as a surround front left and front right? Would the SONOS App allow me to do this?

     

    Thanks.

     

    Adam

    melvimbe
    melvimbe
    May 5, 2020

    Danny,

     

    Just reading back through the comments, what was you opinion of 2 x Front Wall Speakers acting as a surround front left and right? Would the SONOS App allow me to do this?

     

    Thanks.

     

    Adam

     

    I wouldn’t call front speakers ‘surround’ but I get your point.  First, yes, Sonos allows this with the Sonos amp.  As far as it a good idea, I think it is the right solution for you.    Seriously, I think I would do the same describing your situation, and actually have done something similar in a previous home.  I honest don’t have a good feel for how good the phantom center is, but I think this will sound good for TV, and even better for music playback.    I’m using a playbar for TV and music right now, but there are times when I think better front separate would be better, and may switch.  There certainly others on here with the same/similar setup as you don’t regret it.

    Danny
    Tejs Dyrvig Ernst
    May 5, 2020

    I am currently building a new house and will be using the new AMP for TVs. 
     

    Your suggested setup will work. Meaning that you can use two inwall speakers as the two front speakers and the new AMP will create a phantom center-channel. 
     

    Please note that the in-wall speakers must be physically connected to the AMP with speaker wire. They are simply passive speakers. That also means that you are free to look at 3rd party inwalls. The only thing you would be loosing is Trueplay.  
     

    As mentioned, you should also have at least one HDMI-cable installed from the TV to the AMP (more if you would like to keep Apple TV’s, Blu-ray players etc. the same place as the AMP). Otherwise you would need to rely on Airplay 2 and an Apple TV. Consider getting empty tubes installed so you can install and switch cables yourself. From experience, I have seen a lot of HDMI-cables break over time. 
     

    With that all set up, you can wireless expand on the setup by adding 2 Play Ones (or 2 Play Fives, the IKEA-speakers etc) as surrounds and the Sonos Sub as subwoofer. That would bring you to 5.1 (phantom center). 
     

    Again, with the AMP you can also choose a 3rd party sub instead. It needs to be wired to the AMP or have its own transmitter. 
     

    Using a second AMP (or the previous Connect Amp) you can even use 3rd party speakers as rear speakers if that is your thing.

     

     

     

      Terms & ConditionsAccessibility statement