Al was fine, no changes in setup. No changes in other connected devices.
since last couple of day’s My sonos beam does not find the tv anymore.
keeps on asking to Connect to ARC (wich it is) and to check the Samsung settings (anynet+) Which is correct.
what to do?
again, up to last week it worked fine for months
Page 1 / 1
Most likely, the TV stopped talking with the Beam and needs a reboot. To reboot the TV, unplug it for a few seconds, then plug back in. If there are still issues, you may also need to remove the other HDMI attached devices temporarily as they could also be talking to the TV with CEC/Anynet commands.
Note that "turning off the TV with the remote" is not the same thing as what melvimbe is talking about above. You absolutely need to unplug the TV from the wall. This forces the TV to reload all connections, including the HDMI-CEC handshake with the Beam. That handshake should most likely resolve your issues.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.