Skip to main content
rahmanoff
rahmanoff
Avid Contributor III
August 25, 2020
Answered

Projector + Apple TV + Two Amps

Hi!

I want to make HT in such config:

Apple TV - Projector - two AMPs (1 - for Front Speakers, 2 - for Surr Speakers) Sub

I need digital HDMI “switch” box with:

1 - HDMI input - for Apple TV

2 - HDMI output for Projector. Projector have HDMI input.

3 - HDMI ARC output for AMP 1.

Do somebody did same setup?
Do somebody have advice about HDMI “switch”?

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
TimsTelegramAnswer
Trending Lyricist I
December 19, 2020

I’ll save you some trouble. The Arcana would not work for me with the Amp. On the HDFury discord they told me to return the arcana and said they don’t have plans for it to work. Apparently the Arcana is only for Sonos Arc soundbar. I’ve read you might be able to setup the amp with another TV and then try it with the project /AppleTV, but I’m unable to test that. I’ve also just purchased another HDMI ARC converter to see if it will work…

 

OREI 4K 60Hz 18G HDMI 2.0 Audio Converter Extractor - ARC Support - SPDIF + 3.5mm Output - HDCP 2.2 - Dolby Digital/DTS Passthrough CEC, HDR, Dolby Vision HDR10 Support (HDA-925) https://www.amazon.com/dp/B07T6CDPQJ/ref=cm_sw_r_cp_api_glc_fabc_xYK3Fb2ERNM4C

View in thread

23 replies

Show previous replies
soobrex1
Lyricist III
April 13, 2021

@DvC Here’s the one I’ve got: Tendak HDMI Splitter

Perhaps you could do an additional HDMI 1x2 HDMI to duplicate the display to 2 projectors.

    DvC
    Lyricist II
    June 6, 2021

    @soobrex1 Hi again! So I got everything hooked up yesterday only to discover there is a full 3 second delay between the audio input and when the AMP outputs it.

    You read that correctly - 3 FULL seconds, so currently the AMP is completely useless to me for playing audio to sync with the video.

    Do you know if this is a known issue?

    Using the RCA inputs on the AMP, and have tested with headphones from the HDMI/audio splitter (a Tripp-Lite P130-000-AUD4K6).

     

    Thanks,

    David

     

    DvC
    Lyricist II
    June 6, 2021

    @soobrex1 OK, I’m an idiot. Found the ‘audio delay’ setting, and set it to ‘low’ (was on ‘Max 2000ms’).

    All good! :)

      Terms & ConditionsAccessibility statement