Skip to main content
Jelle Nilsson
Contributor I
May 7, 2019 8:45 PM UTC
Question

Line In Deactivated - Connect & Turntable

I just got my Sonos Connect, and I thought I was able to connect it to my Pro-Ject Essential III turntable. Everything checked out just fine, exept, The Line In is set to deactivated. I can change it. Without it being activated I can use my turntable as an extern source.
    This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

    7 replies

    John B
    May 7, 2019 9:55 PM UTC
    Please could you explain what you mean by 'set to deactivated'?
    Translate
      Jelle NilssonAuthor
      Contributor I
      May 9, 2019 9:56 PM UTC
      Under the 'Line In' option, it simply states, deactivated (in Danish) as to say that it is not on? But I have no chance to turn it on.
      I have posted a screenshot.
      Translate
      Airgetlam
      Airgetlam
      May 9, 2019 10:24 PM UTC
      Are you sure that you have something plugged in to the analog line in? It normally wouldn't show up at all, as far as I know, if there wasn't anything plugged in, but I've never heard of it not being able to be "activated" before. I might be tempted to power cycle the CONNECT.
      Translate
      Bruce
      Ken_Griffiths
      Ken_Griffiths
      May 9, 2019 11:44 PM UTC
      Jelle Nilsson,

      That actually looks to me like a “line-out” source screen rather than your “line-in” .. I don’t have a “Connect” so can you perhaps double-check that, as my Danish is also non-existent. I think you’re looking in the wrong place in the App... er, perhaps?
      Translate
      John B
      May 10, 2019 7:35 AM UTC
      I suspect, based on my English app, that this is actually 'disconnected'. That is, no cable is detected in the line in connection. If there is a cable there, have you mistakenly put it in the line out?
      Translate
      106rallye
      106rallye
      May 10, 2019 7:34 PM UTC
      Does your turntable have a built in phono-amp? If not the signal may not be strong enough for the Connect to register it and notice the line in is in use. See https://en.community.sonos.com/music-services-and-sources-228994/using-a-turntable-with-sonos-6769426
      Translate
        John B
        May 10, 2019 7:52 PM UTC
        Does your turntable have a built in phono-amp? If not the signal may not be strong enough for the Connect to register it and notice the line in is in use. See https://en.community.sonos.com/music-services-and-sources-228994/using-a-turntable-with-sonos-6769426The Connect will show the line in as connected even if there is no device attached to the cable, so it won't be anything to do with the signal strength.
        Translate
        Terms & ConditionsAccessibility statement