I have two generation 1 (S1 app) sonos Connects - using line in.

3 replies
162 views
Translate All

One of the connects is connected to my home theater receiver and the other is connected to a strereo receiver in another room with a turntable. How can I get music playing on the line-in input to play on the other system? Both are in the same group.

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

A

Another OneAnswer

Contributor I

I found the problem. Thanks for all the suggestions.

The line level output was TOO LOW for the connect system, so even though it showed the line in as active there was not enough impendence to work. All is good now!

Airgetlam

Are both CONNECTs part of the same system? I.e when you open the controller, do you see ‘both’? If not, you’ll need to factory reset one of them, and add it as a ‘new device’ to the other system, using the controller.

Translate

Bruce

106rallye

You state “both are in the same group”. Since “group” is a Sonos term, I am confused about what you mean by this. A Sonos system consists of “rooms”(either stand alone speakers or fixed stereo or surround set ups) that can be “grouped”, see https://support.sonos.com/en/article/group-and-ungroup-rooms. On top of that multiple rooms can also form “zones”.

In this sense you saying “both are in the same group” confuses me.

Translate

A

Another OneAuthorAnswer

Contributor I

I found the problem. Thanks for all the suggestions.

The line level output was TOO LOW for the connect system, so even though it showed the line in as active there was not enough impendence to work. All is good now!

Translate

Sign up

Login to the community