Dj mixer 2x technics 1210 maranrz amp sonos connect gen1

sonos app now says line in disconnected because its in out  

This is known as the ‘S1’ controller. Now connect the mixer output to the SONOS CONNECT’s Line-In.

ok one sec

ok set up now out put mixer to line in  sonos connect  and  sonos connect out to tuner … still no sound coming from amp and other speakers 

Then i cant use tuner input  like you mentioned 

network i mean

no sonos radio going through amp  app controller saying no music selected

o boy now sonos controller has sent me to 2 app and i cant find precious line in etc 

I have come to the conclusion sonos connect 1 zone player no longer works  may be due to updates .

I’d expect more people to be complaining if an update caused an issue with their ‘Connect’. This community would ‘light up’ if that was the case.

If your TT has a pre-amp - perhaps simplify things for now as a test and wire it to the Connect line-in and play the ‘line-in’ source from ‘Your Sources’ in the Sonos App to one of your Sonos speakers (Ray etc.)

Then go onto cable the ‘Connect’ line-out to one of your Amp line-in RCA analog sources (say CD or Tuner) and using the Sonos App, play Sonos Radio to the ‘Connect’ and select the chosen Amp input to see if it plays on your Amp speakers, or maybe listen via Headphones connected to the Amp - (check volume levels on Amp and in the Sonos App too).

Once you know if things are then working correctly, you can go onto add in the Citronic mixer afterwards. Not sure what you might think about the ~75ms audio buffer (delay) that Sonos has in place for line-in and grouped room audio, but that’s perhaps a discussion for another day. 

I would try to keep things simple at this stage, at least until you know that things are working and that there isn’t a fault.