Connect:amp s2 does not setup and button press is not recognized

Forum|Forum|1 year ago
May 2, 2025
4 replies
423 views

Hello I have a connect:amp s2. I have had it previously connect to my system and it worked fine. I recently change out some components and removed all of the S2 amps. I want to now add one back in and it will not go past the press the button on your connect:amp page. The button press is never recognized.

I have read of a couple of instances of this happening but did not see any resolution to this issue, anyone run into this?

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

Best answer by Pools-3015

Have you tried connecting the amp directly to your router? If that does not work, I would calling support. They have tools to troubleshoot problems better that we can here.

Pools-3015Answer

Prodigy I

Have you tried connecting the amp directly to your router? If that does not work, I would calling support. They have tools to troubleshoot problems better that we can here.

N

Nismos14Author

Contributor I

Have you tried connecting the amp directly to your router? If that does not work, I would calling support. They have tools to troubleshoot problems better that we can here.

Then it doesn’t reconnect to wifi after removing ethernet.

Pools-3015

Prodigy I

Have you check for firmware updates while connected with a cable?

N

Nismos14Author

Contributor I

Have you check for firmware updates while connected with a cable?

It was fully updated just a couple of weeks ago when I had previously connected it

Sign up

Login to the community