1 Amp 2 VC 3 Sets of Speakers

Forum|Forum|2 years ago
July 28, 2024
7 replies
79 views

Hi, I have one amp currently powering one set of speakers on my porch with a volume control. I'm thinking about adding an additional two pairs of speakers inside. Id like to put them on a seperate volume control and if possible also on the same amp. Firstly would it be possible to have all 6 speakers on one amp and second, what would I set the impedence matching to. From what I understand if it were two pairs on one VC id set it to 2X. However I'll have one pair on one VC and two pairs on the other. Would I set both VC to 4x?

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

buzz

Grand Maestro

I recommend using three Volmue controls. Proper setting depends on the speaker impedance. The control manufacturer should give you a table of suggested settings based on speaker impedance and amplifier minimum impedance capability.

A

AltechAuthor

Contributor I

The two pairs indoors are going in the same room though so it would be funny to put in a second vc

Stanley_4

Grand Maestro

If not matched pairs or you aren't sitting in the optimal position the additional volume control might be nice.

A

AltechAuthor

Contributor I

Still, ideally I'd like to use only one VC for indoors

buzz

Grand Maestro

Use a single control for the inside room if you like. If the Volume controls are configured properly, AMP will not care.

A

AltechAuthor

Contributor I

Ok, what would I set the VC to tho? Would I chance both to 4x? 1 to 2x one to 1x?

buzz

Grand Maestro

Since I know nothing about your speakers, I suggest 4x. If AMP shuts down at high Volume, then go with 8x. 1x on the outdoor speaker and 2x on the indoor pair could work — depending on the speakers, the wiring, and your listening level.

Sign up

Login to the community