Skip to main content
Kcontzen
Contributor I
November 20, 2020

Connect - no sound

  • November 20, 2020
  • 15 replies
  • 1560 views

I have a system with one connect and three connect:amps, no sound plays from the connect. 
 

I have them grouped, with audio coming via line-in on one of the units. Which unit the line in is hooked up to (connect or one of the connect:Amps) has no effect on the problem. The connect line out is hooked up to a receiver. I’ve hooked another source up to the receiver’s line in and it plays fine. 
 

If I have the line in hooked up to the connect, all units grouped, I get sound out of the connect:amps but nothing seems to be coming from the connect line out. The Sonos app shows them all playing and volume is turned up.  Any ideas what I’m doing wrong with this setup?


Thanks!! 

 

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

15 replies

KcontzenAuthor
Contributor I
November 20, 2020

I’ve submitted diagnostics, number 790132414

Mark P
Mark P
Retired Sonos Staff
November 21, 2020

Hi @Kcontzen.

Welcome, thank you for reaching out to Sonos Community and providing the diagnostic report since you already tried all troubleshooting steps let me help you further.

Try unplugging all Sonos devices from power, then reboot your router. Once the router comes back up, plug your Sonos devices back in.

Let us know if it works. If you need help with any other information, please be sure to let us know.

Help others find useful content by clicking the like button and selecting the best answer to your question
KcontzenAuthor
Contributor I
November 21, 2020

Hi - thanks for the help! I’d tried rebooting the components but not all together in this order. I just did that and the problem seems unchanged, audio everywhere except from the connect. Redid the diagnostics at number 1788861698

Ken_Griffiths
Ken_Griffiths
November 21, 2020

Have you tried switching the connect line audio-out from ‘variable’ to ‘fixed’, or vice versa - make sure the volume level on the receiver line-in is not set too high before trying it.

KcontzenAuthor
Contributor I
November 21, 2020

Yes, I’ve tried variable, fixed and pass-through and there’s no change. 

ratty
ratty
November 21, 2020

The Connect could have a failed analog output stage. It’s known to happen. One option is to put a cheap DAC on one of the digital outputs instead. 

    Ken_Griffiths
    Ken_Griffiths
    November 21, 2020

    Yes, I’ve tried variable, fixed and pass-through and there’s no change. 

    I will assume you have already checked the lead/connections, as it’s quite clear you already know what you are doing with these devices. But… have you tried a factory reset of the Connect? I have seen that fix this type of issue when mentioned on some old threads here in the past.

    KcontzenAuthor
    Contributor I
    November 21, 2020

    I only have the one connect; the others are amps so they don’t have a line out or digital audio outs. 
    edit - responding to an edited comment so just ignore this

    KcontzenAuthor
    Contributor I
    November 21, 2020

    Just tried the factory reset and that hasn’t changed anything. I don’t have a toslink cable available but I’ll pick one up and try the digital out. 

    ratty
    ratty
    November 21, 2020

    As a temporary measure, try using one of the RCA analog cables to connect the digital coax out to a suitable input on the receiver. So long as it’s not very long it should work, at least as an experiment. 

      Show more replies
      Terms & ConditionsAccessibility statement