Skip to main content
Zacharias
Contributor III
April 6, 2013

ZP100 not booting

Hi,

I've recently acquired a ZP100 however it looks to be stuck in the boot process with a single white light flashing endlessly.

It doesn't appear responsive to holding the mute button on bootup. On powerup all of the network port light flash briefly and the connection lights are solid if wired to bridge via ethernet.

I know this is an old product and I know it is my fault for purchasing it, but is there any other reset tricks or way to update the firmware to get out of this loop?
    This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

    192 replies

    Show previous replies
    AmonRa
    Lyricist II
    January 28, 2019
    Hello everyone, I have a zp100 bought on eBay constantly flashing white, not pinged. also bought PL2303HX cable firm FTDI USB to TTL module data conversion adapter Arduino memory UART via RS232 I read the topic several times but did not understand how to update the firmware, and if possible, write a command line Windows. forgive me for my English.
    AmonRa
    Lyricist II
    January 30, 2019
    Rincon boot loader version 1.0-27270(ZP) (32M SDRAM). Press 'h' for help.
    SDRAM test...
    Memory test iteration 0
    SDRAM test complete
    Attempting to autoboot from NAND device
    NAND ID is 20:75
    32M NAND flash (ST NAND256W3A) detected
    Uncorrectable ECC error, page 0 (first half)
    No valid partition table, defaulting to old boot mechanism
    nand_load: page appears to be blank, page 512
    Sorry, autoboot failed


    nand dead?
    Terms & ConditionsAccessibility statement