Skip to main content
Sullydks
Renowned Enthusiast I
Sep 29, 2017 8:25 PM UTC
Question

ZP 100 Spec

Where can I find info on the original spec of the initial ZP100's . Output , channel etc..
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

8 replies

Lucid AV
Prodigy I
Oct 1, 2017 5:23 PM UTC
Output power: 50wpc

Wi-Fi: 2.4GHz only

Channel: 6 I believe. Accessible from the controller app. Alterable from the app to channels 1, 6, 11 I think

Translate
If this or any other posts have been helpful then show your appreciation by clicking on the thanks button. Its a great way to say Thank You. :)
Sullydks
SullydksAuthor
Renowned Enthusiast I
Oct 3, 2017 4:48 PM UTC
Thanks folks.
I was after the Watts and Ohms ratings.
Seeking to put a reasonably good pair of floor standing speakers onto one ZP 100. Wanting to check compatibility.


Cheers.
kev
Translate
====, Synology NAS. FLAC only.
Belly M
Oct 3, 2017 5:20 PM UTC
50w into 8 ohms
Translate
Lucid AV
Prodigy I
Oct 3, 2017 5:49 PM UTC
Ah, if you'd said you needed Ohms too.

Anyway, FWIW, the current drive from the amp is a little limited compared to a decent Hi-fi amp. Good floor-standers should be pretty efficient (88-91dB is typical for coil speakers), you just need to watch the maximum volume and avoid anything in a speaker that's too revealing.

The ZP100 definitely sounds better than the later ZP120/Connect Amp.
Translate
If this or any other posts have been helpful then show your appreciation by clicking on the thanks button. Its a great way to say Thank You. :)
jgatie
Oct 3, 2017 6:40 PM UTC
50 W @ 8 Ohms.
Translate
Andy B
Sonos Staff
Oct 3, 2017 6:44 PM UTC
We have the original product documentation available as well.
Translate
Sullydks
SullydksAuthor
Renowned Enthusiast I
Oct 30, 2017 10:56 PM UTC
Thanks all.
Andy. Thanks but That link isn’t to the original docs. The Original doc wouldn’t have referred to PLAY series’s cos they didn’t exist. I’ll dig out the manuals from 1st editions. Got the hard copies somewhere.

Question.
So would. 4ohm speaker be incompatible. I never remember which way around.
Translate
====, Synology NAS. FLAC only.
Sullydks
SullydksAuthor
Renowned Enthusiast I
Oct 30, 2017 11:22 PM UTC
Many articles I can find on matching impedance to Amp output refer to voltage output of the amp. Anyone know the voltage output of the zp 100. Does it matter?

I’m considering a pair of 4ohm Speakers,Frequency Range: 33Hz – 22kHz.

Will the ZP100 run hot driving these?
What do I need to check ?
Translate
====, Synology NAS. FLAC only.