Skip to main content
Contributor I
Apr 25, 2022 5:58 PM UTC
Answered

possible to select specific mesh node for Roam?

Hi,

I have a very simple system that works fairly well: 2 Roam speakers connecting to an Asus mesh system with two nodes (the one wires to fios router and one satellite node).  
It works fine when the speakers are indoors but the speakers start to drop when I go outdoors.  I gather it’s due to a relatively poor wifi signal BUT I noticed that the speakers connect only to the wifi signal coming from the router that’s hardwired to the Fios router, even though the other node is much much closer to the speakers.  
Q: Is there any way to force the Roam to connect to the nearest node?

Thanks in advance,

Frank

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Ken_Griffiths
Apr 25, 2022 7:35 PM UTC

Have you perhaps tried powering off the Roam fully and powering it on again when actually outdoors, to see if it then connects to the nearby node on startup instead?

4 replies

Ken_Griffiths
Apr 25, 2022 7:35 PM UTC

Have you perhaps tried powering off the Roam fully and powering it on again when actually outdoors, to see if it then connects to the nearby node on startup instead?

Translate
Contributor I
Apr 25, 2022 7:53 PM UTC

hi does your mesh have a seamless roaming function? may be you need to turn that setting on.  i know my tp-link deco does which automatically moves your device to the nearest node but i had turn on that feature as it was not on by default.

Translate
FgiblinAuthor
Contributor I
Apr 25, 2022 10:04 PM UTC

Have you perhaps tried powering off the Roam fully and powering it on again when actually outdoors, to see if it then connects to the nearby node on startup instead?

I haven't tried that yet but will give it a go. 

Translate
FgiblinAuthor
Contributor I
Apr 25, 2022 10:06 PM UTC

hi does your mesh have a seamless roaming function? may be you need to turn that setting on.  i know my tp-link deco does which automatically moves your device to the nearest node but i had turn on that feature as it was not on by default.

I believe it does, in that other devices will change ip the node they are connecting to.   Not sure if the Roam might have similar setting though.  

Translate