Skip to main content
Contributor I
May 3, 2017 11:28 PM UTC
Question

need more volume in a couple of zones

can i add more power to the connect system from another source?
    This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

    11 replies

    May 4, 2017 1:20 AM UTC
    If by more power you mean more volume in more areas, yes; play units are the simplest adds.
    Translate
    martinj8Author
    Contributor I
    May 4, 2017 1:38 AM UTC
    Play units? Are you speaking of slave amps?
    Translate
    May 4, 2017 1:44 AM UTC
    No, Sonos play units; these are active Wifi speakers that play in perfect sync with Connect. More volume in more parts of the space.
    Translate
    martinj8Author
    Contributor I
    May 4, 2017 1:21 PM UTC
    I have existing hard wired ceiling and outdoor speakers which the connect amps aren't quite driving well enough, I was hoping I could add some wattage somehow to the system to increase the sound levels
    Translate
    May 4, 2017 2:03 PM UTC
    If the objective is to increase sound levels, well placed play 1 units are the simplest way to do the job. Adding wattage isn't efficient; you need to double the wattage for a 20% increase in sound levels. Assuming that the speakers can handle this extra power.
    Translate
    martinj8Author
    Contributor I
    May 4, 2017 2:14 PM UTC
    Sonos does not make or endorse outdoor speakers, and that's the area that's falling short on volume, also I'm looking to find a sum to mono work around from poorly designed placement of wired niles outdoor speakers
    Translate
    May 4, 2017 2:29 PM UTC
    Getting more volume from a given set of speakers is even more of a challenge out of doors where sound energy is rapidly lost with distance from the speakers. Relocating speakers to get them closer to listening areas is the answer. The mono workaround needs some DIY with resistors and a soldering iron.
    Translate
    martinj8Author
    Contributor I
    May 4, 2017 2:47 PM UTC
    I was planning on adding the rotel 8 channel D/A amp to my system which would eliminate most of the sonos connect amps except for kitchen where I have the sonos sub, which can only work with there amp. The rotel has a mono feature for up to 2 zones which is perfect also bumps power to 100 watts
    of very clean power. What do you think about that?
    Translate
    May 4, 2017 3:22 PM UTC
    That will solve your mono needs, but I can't see that small a power bump doing much for getting higher volumes out of doors. But I doubt you can solve that problem with the installed speakers because with more power than 100 watts you will almost certainly hit their power handling limits and burn them out.

    With 100 watts per channel as compared to 55 per channel from the Connect Amps, don't expect more than a little increase in perceived volume levels out of doors. Note that the 55 watts from Connect Amp is just as clean!
    Translate
    martinj8Author
    Contributor I
    May 4, 2017 5:46 PM UTC
    Thank you for the info, your very up to date on current tech
    Translate